BMW 7 Series (F01/F02) 2008-2015 Service Manual / Heating And Air Conditioning
BMW 7 Series: Heating And Air Conditioning
- General
- Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
- Safety Information For Working On Vehicles With Automatic Engine Start-Stop Function (MSA)
- Heater With Operation
- Installing Servodrive
- Removing And Installing Fan Housing For Heater/Air Conditioner Fan
- Removing And Installing/Replacing Auxiliary Water Pump
- Removing And Installing/Replacing Control Panel For Rear Cabin A/C System
- Removing And Installing/Replacing Heating And Air-Conditioning Unit
- Removing And Installing/Replacing Radio And A/C Control Panel
- Replacing Actuator Drive For Fresh Air/Ram Air
- Replacing Actuator Drive For Left Footwell Flap
- Replacing Actuator Drive For Left Rear Cabin Footwell Flap (High A/C System)
- Replacing Actuator Drive For Right Footwell Flap
- Replacing Actuator Drive For Right Rear Cabin Footwell Flap (High A/C System)
- Replacing Controller For Heating And A/C System Fan
- Replacing Interior Temperature Sensor Blower (A/C Control Panel)
- Replacing Water Valve For Heater (N63)
- Auxil. Heater With Control Elements
- Initializing Telestart Handheld Transmitter
- Removing And Installing Complete Independent Heater
- Removing And Installing Or Replacing Fuel Pump
- Removing And Installing/Replacing Exhaust Pipe
- Nozzles And Outlets
- Microfilter
- Air Conditioning System
- A/C Performance Test (R 134a)
- Drawing Off, Evacuating And Filling Heating And Air Conditioning System (R 134a)
- Instructions For Handling R 134a Refrigerant
- Leak Detection With Forming Gas
- Leak Detection With Ultraviolet Additives (UV Additives) (BMW Leak-Testing Case)
- Overview Of Heater - A/C System Components
- AC Housing Evaporator, Switching Elements
- Cleaning Evaporator
- Instructions For Opening And Replacing Parts In Refrigerant Circuit
- Removing And Installing Or Replacing Expansion Valve
- Removing And Installing/Renewing Evaporator
- Removing And Installing/Replacing Evaporator For Rear Air Conditioner
- Compressor
- Instructions For Compressor Replacement
- Instructions For Opening And Replacing Parts In Refrigerant Circuit
- Removing And Installing/Replacing A/C System Compressor (N63)
- Removing And Installing/Replacing Heating And Air Conditioning System Compressor (N63, With Dynamic Drive)
- Condenser And Dryer With Lines
- Instructions For Desiccant Insert Replacement
- Intake Pipe From Connecting Piece To Automatic Rear Air-Conditioning System
- Pressure Line From Connecting Piece To Rear Heater - A/C System
- Removing And Installing/Replacing Capacitor For The Heating And Air Conditioning System (N63)
- Replacing Desiccant Insert For Air Conditioning System
- Instrument Cluster
- Head-Up Display
READ NEXT:
Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
WARNING: Use of cleaning agents/paints not compliant with instructions
can cause
serious injuries or burns!
Handling cleaning agents/paints can trigger allergic skin and respiratory
reactions!
IMPORT
Safety Information For Working On Vehicles With Automatic Engine Start-Stop
Function (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode),
the information "switch closed" is output. The automatic engine start-stop
function is active.
An automatic engine start
SEE MORE:
Handheld Computer
REMOVING AND INSTALLING (REPLACING) HANDSFREE CHARGING
ELECTRONICS (HIGH)
Operation is described in:
REMOVING AND INSTALLING (REPLACING) HANDSFREE CHARGING ELECTRONICS
(OPTIONAL EXTRA SA644)
Replacement
Carry out VEHICLE PROGRAMMING/ENCODING
REMOVING AND INSTALLING (REPLACING) HANDSFREE CHARGING
Carbon Canister Ventilation
REPLACING TANK VENTING VALVE (N63)
Necessary preliminary tasks
Check stored fault message.
Switch off ignition.
Remove FAN COWL.
Unlock connector (1) and remove.
Unlock hose (2) and detach.
Unlock hose (3) further below on intake manifold and detach.
Detach tank vent valve (4) from holder an
© 2019-2026 Copyright www.bmw7g11.com
