BMW 7 Owners & Service Manuals

BMW 7 Series: Compressor

READ NEXT:

 Instructions For Compressor Replacement

Notes IMPORTANT: Compressors with plastic belt pulleys: Avoid impacts/knocks to plastic belt pulley (caused by tools, contact with base). Return faulty compressors in their original packaging on

 Instructions For Opening And Replacing Parts In Refrigerant Circuit

WARNING: Avoid contact with refrigerant and refrigerant fluid. Follow safety information for handling R134A refrigerant. Follow safety information for HANDLING REFRIGERANT FLUID. IMPORTANT:

 Removing And Installing/Replacing A/C System Compressor (N63)

Notes WARNING: Danger of injury! Refrigerant circuit is under high pressure! Follow safety instructions for handling R 134A refrigerant. Avoid contact with refrigerant and refrigerant fluid. Follow

SEE MORE:

 Replacing Entrance With Door Post, Left And Right (Partial Replacement, B-pillar)

Observe procedure of REPAIR STAGE 3. Read CONTENTS OF BODY, GENERAL. Spot-weld bonding is used on this vehicle. Observe specific PROCEDURE. Use only approved spot-welding apparatus for repairs. Place vehicle on straightening bench. The following new body parts are required (see BMW Electronic P

 Replacing Interior Temperature Sensor Blower (A/C Control Panel)

Necessary preliminary work Remove RADIO AND IHKA CONTROLS Release screws (1). Tightening torque 61 31 2AZ. NOTE: Use special tool 00 9 450 to tighten screws. Remove fan (2) from IHKA controls (3). Installation note: Make sure pins (4) are correctly located on fan (2). Fig. 101: Identifying Fan

© 2019-2025 Copyright www.bmw7g11.com