BMW 7 Series: Radio
FM Stations
The layout of the "FM stations" in the Radio menu has been adapted to the new operating concept.
The former layout of the "All stations" list in the form displayed by the CCC has been replaced in the CIC by a list layout.
.png)
Fig. 44: FM Menu "All Stations" In CCC
.png)
Fig. 45: FM Menu "All Stations" In CIC As List
.png)
Fig. 46: Manual Station Search In CIC System
.png)
Fig. 47: Manual Station Search In CCC System
AM Stations
A double tuner has now made it possible to receive the "All stations" list in the AM range. However, no station information can be displayed because the RDS data is not transmitted for AM.
.png)
Fig. 48: AM Stations List
.png)
Fig. 49: AM Stations Manual Setting
IBOC
The IBOC functions in connection with the IBOC decoder which is now installed inside the CIC. IBOC makes it possible to receive digital radio signals. The IBOC components are described in detail in the "System Components" section of this training material.
SDARS
The Satellite radio service is available with a subscription to Sirius satellite radio. An example of how a station list would look like in the CIC with channels that have not yet been subscribed to is shown in the illustration below.
.png)
Fig. 50: Station List With SDARS Channels Still Disabled
Stored Stations
Under the menu item "Stored stations", the required stations from all frequency ranges can be stored in a common menu and then selected at a later time.
The following frequency bands are available for storage:
- FM
- AM (SW, MW, LW)
- IBOC
.png)
Fig. 51: Stored Stations
READ NEXT:
Telephone
The pairing assistant for the Bluetooth connection can be found under
"Bluetooth" in the Telephone menu.
Up to four mobile phones can be paired. One of the mobile phones already paired
must be remo
Navigation
Fig. 57: View Of Navigation System's "Speller" For Entering Destinations
NAVIGATION EXPLANATION CHART
Speller
Fast access
Selection menu
To simplify the destination entry procedure, the speller
Vehicle Information
There are three sub-groups that can be selected in the "Vehicle info" menu:
Onboard computer
Trip computer
Vehicle status
Onboard Computer
The onboard computer takes the place of the trip compute
SEE MORE:
Cover For Frame Side Member (Part Replacement Between A And B
Pillar)
Observe procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
Following new body parts are required:
B-pillar with entrance
Fig. 251: Identifying B-Pillar With Entrance
Fig. 252: Identifying Welded Connections Areas
Mark severance cuts in accordance with specified measurements and cut
Vibration Damper
REMOVING AND INSTALLING/RENEWING VIBRATION DAMPER (N63)
Necessary preliminary work
Remove FAN COWL
Remove A/C compressor DRIVE BELT
Remove alternator DRIVE BELT
Remove belt pulley for A/C system
Release screw (1).
Tightening torque 11 28 1AZ.
Remove belt tensioner with idler pulley (2).
Fig
