BMW 7 Series: Telephone
The pairing assistant for the Bluetooth connection can be found under "Bluetooth" in the Telephone menu.
Up to four mobile phones can be paired. One of the mobile phones already paired must be removed from the displayed list in order to pair a fifth mobile phone.
.png)
Fig. 52: Bluetooth In Telephone Menu
Follow the steps below to pair a Bluetooth telephone:
- After selecting "Add new phone" the identification number of the vehicle is shown in the display.
- The pairing assistant now receives the message that it is necessary to proceed with the mobile phone.
- A search for new Bluetooth devices should now be conducted on the mobile phone.
.png)
Fig. 53: Add New Phone Display
- If the search was successful, the identification number of the vehicle will be shown in the mobile phone display.
.png)
Fig. 54: Identification Number Of Vehicle - Mobile Phone Display
- A free random PIN-CODE must now be entered in the mobile phone which must then be repeated in the vehicle.
.png)
Fig. 55: Identifying Free Random PIN-CODE
Following successful pairing, the data of the paired mobile phone device is now displayed in the phonebook or contact. This procedure can take from several seconds up to several minutes to complete depending on the amount of entries stored.
.png)
Fig. 56: Mobile Phone Device Connected Displayed
READ NEXT:
Navigation
Fig. 57: View Of Navigation System's "Speller" For Entering Destinations
NAVIGATION EXPLANATION CHART
Speller
Fast access
Selection menu
To simplify the destination entry procedure, the speller
Vehicle Information
There are three sub-groups that can be selected in the "Vehicle info" menu:
Onboard computer
Trip computer
Vehicle status
Onboard Computer
The onboard computer takes the place of the trip compute
Service Information
UNLOCKING THE SERVICE MENU OPTION
Several important functions can be checked directly at the CIC with the aid
of the Service menu. This menu can
be used to select and adjust settings that are not vis
SEE MORE:
Safety Information For Working On Vehicles With Automatic Engine
Start-Stop Function (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode),
the information "switch closed" is output. The automatic engine
start_stop function is active.
An automatic engine start is possible.
Observe safety precautions when working on MSA vehicles
Before carrying out practical
Replacement And Start-Up
Removing and installing the ICM control unit
The ICM control unit performs tasks that are important for many vehicle
functions, e. g. provision of sensor
signals. If the vehicle were operated without the ICM control unit installed, a
large number of vehicle functions
would not be available. In the
