BMW 7 Series (F01/F02) 2008-2015 Service Manual / Heating And Air Conditioning / General / Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
BMW 7 Series: Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
WARNING: Use of cleaning agents/paints not compliant with instructions can cause serious injuries or burns! Handling cleaning agents/paints can trigger allergic skin and respiratory reactions!
IMPORTANT: Observe following instructions:
- Store cleaning agents/paints only in a secure cabinet.
- Keep cleaning agents/paints away from naked flames and other sources of ignition.
- Protect cleaning agents/paints from high temperatures and direct sunlight.
- Always keep an eye bath on hand, change the water regularly (once a month).
IMPORTANT: Observe following instructions before use:
- Manufacturer's instructions (on container/packaging)
- Hazard warnings (on container/packaging)
- Manufacturer's instructions on package insert
- Material safety data sheet of manufacturer
- Product information in EPC
- National market regulations
IMPORTANT: Observe following instructions during use:
- Do not eat, drink or smoke while working with these products.
- Avoid direct contact with skin and eyes.
- Wear personal protective clothing/equipment.
- Ensure that all enclosed areas are well ventilated or extract fumes directly.
- Immediately change working clothes soiled with cleaning agent/paint.
- After finishing work, wash your hands and apply protective skin cream.
IMPORTANT: Follow hazard warnings and wear personal protection equipment!
First Aid
- If product comes in contact with eyes, immediately flush with running
water for about 10 - 15 minutes.
Seek the advice of eye specialist.
- In the event of skin contact and where applicable an allergic skin reaction, clean the affected areas immediately with soap and water and then apply silicone-free skin cream. Seek advice of physician.
- If an adhesive product is swallowed, rinse mouth/parts of mouth thoroughly with running water. Drink 1- 2 glasses of water. Do not induce vomiting. Consult a doctor.
- After inhaling vapors ensure ample supply of fresh air. Keep calm, keep respiratory tracks clear and call doctor.
Recycling
Dispose of cleaning agents/paints in a professional manner! Observe national/country-specific disposal regulations.
OVERVIEW OF HEATER - A/C SYSTEM COMPONENTS
.png)
Fig. 1: Overview Of Heater And A/C System Components
- Condenser for air conditioner
- Drier insert for air conditioner
- Independent heater and attachment parts
- Water valve
- Heater - A/C system and attachment parts
- Fan and attachment parts
- Compressor
READ NEXT:
Safety Information For Working On Vehicles With Automatic Engine Start-Stop
Function (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode),
the information "switch closed" is output. The automatic engine start-stop
function is active.
An automatic engine start
Installing Servodrive
Installation:
If necessary, align shaft of flap(s) to be actuated to position of servodrive
to be installed.
Fig. 4: Identifying Servodrive Position
OVERVIEW OF ACTUATOR DRIVES ON HEATER/AIR CONDITI
SEE MORE:
Rear Axle Layout
Fig. 8: Rear Axle Layout
Overview, rear axle support with rubber mount
Overview of rear differential/output shafts
Compression strut, front
Overview of steering links
Anti-roll bar link
Anti-roll bar / rubber mount
Shock absorber / support bearing
Coil spring
Wheel bearing / drive flange
Lane departure warning- Warning function
If you leave the lane
If you leave the lane and if a lane marking has
been detected, the steering wheel vibrates in accordance
with the steering wheel vibration setting.
When the turn signal is switched on in the corresponding
direction before changing the lane, a
warning is not issued.
Steering in
© 2019-2026 Copyright www.bmw7g11.com
