BMW 7 Series: General
- Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
- Safety Information For Working On Vehicles With Automatic Engine Start-Stop Function (MSA)
READ NEXT:
Information On Using Cleaning Agent/Paints (Personal Protection Equipment)
WARNING: Use of cleaning agents/paints not compliant with instructions
can cause
serious injuries or burns!
Handling cleaning agents/paints can trigger allergic skin and respiratory
reactions!
IMPORT
Safety Information For Working On Vehicles With Automatic Engine Start-Stop
Function (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode),
the information "switch closed" is output. The automatic engine start-stop
function is active.
An automatic engine start
SEE MORE:
Lane Change Warning
REMOVING AND INSTALLING/REPLACING SENSOR FOR LANE CHANGE WARNING
(HC2 SENSOR) ON LEFT OR RIGHT
Necessary preliminary work
Remove REAR BUMPER TRIM
Disconnect plug connection (1).
Unfasten screws (2).
Remove HC2 sensor (3).
Fig. 21: Identifying HC2 Sensor And Plug Connection With Screws
IMPORTAN
Removing And Installing/Replacing Feed Line (N63)
Notes
WARNING: Clamp off BATTERY NEGATIVE TERMINAL (risk of fire due to
shortcircuiting
on removal).
Electric fuel pump starts up automatically when door is opened!
Carry out installation work on fuel system only with coolant temperature
below 40ºC.
Wear protective goggles.
Wear protective glove
© 2019-2026 Copyright www.bmw7g11.com
