BMW 7 Series: Overview Of Heater - A/C System Components
.png)
Fig. 136: Overview Of Heater And A/C System Components
- Condenser for air conditioner
- Drier insert for air conditioner
- Independent heater and attachment parts
- Water valve
- Heater - A/C system and attachment parts
- Fan and attachment parts
- Compressor
REMOVING AND INSTALLING OR REPLACING LEFT FRESH-AIR GRILLE
Necessary preliminary tasks
- Remove DECORATIVE STRIP ON INSTRUMENT PANEL ON LEFT
NOTE: Example graphic on the F01.
Release screws (1).
Pull out left fresh-air grille (2) towards front and unlock and disconnect plug connection behind.
Remove left fresh-air grille (2).
.png)
Fig. 137: Removing Left Fresh-Air Grille And Screws
Installation: Catches (1) of fresh-air grille (2) must not be damaged.
Make sure fresh-air grille (2) is correctly seated on fresh-air duct behind.
.png)
Fig. 138: Identifying Fresh-Air Grille And Catches
REMOVING AND INSTALLING/RENEWING REAR COMPARTMENT FRESH-AIR GRILLE (BASIC A/C SYSTEM)
Installation
- Remove REAR CENTRE CONSOLE TRIM
NOTE: Example graphic on the F01.
Release screws (1).
Snap out retainers (2) and press out fresh-air grille (4) towards front.
Remove fresh-air grille (4) from center console trim (3).
.png)
Fig. 139: Identifying Fresh-Air Grille, Centre Console Trim And Screws
Installation
Retaining lugs and retainers must be correctly seated in associated guides and must not be damaged.
READ NEXT:
Removing And Installing/Replacing Center Fresh Air Grille
Necessary preliminary work
F01, F02, F03, F12, F13:
Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE
F07, F10, F11, F18:
Remove decorative strip on dashboard on right
IMPORTANT: Proceed with care
Microfilter
Overview Of Heater - A/C System Components
Fig. 148: Overview Of Heater And A/C System Components
Condenser for air conditioner
Drier insert for air conditioner
Independent heater and attachment
SEE MORE:
Electronic Components
OVERVIEW OF ELECTRONIC COMPONENTS
Fig. 153: Overview Of Electronic Components
Pulse generator
Brake pad wear sensor
ICM control unit
DSC control unit
REMOVING AND INSTALLING/RENEWING ICM CONTROL UNIT
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DAMAGE (ESD prote
Introduction
Windscreen Wipers
The F01/F02 has a wiper/washer system for the windscreen as standard.
Windscreen wiping has the following functions:
Continuous wipe in stage 1
Continuous wipe in stage 2
Flick wipe.
The following systems are also available:
Headlight washer system
Water jet heater
Automa
