BMW 7 Owners & Service Manuals

BMW 7 Series: Initializing Telestart Handheld Transmitter

NOTE: The Telestart hand-held transmitter must be initialized when:

  • Hand-held transmitter is replaced
  • Car Access System control unit is replaced

The auxiliary heating is switched on under an ambient temperature of approx. 15ºC with the hand-held transmitter and at a preselected switch-on time.

Heating can be activated directly in the Central Information Display at any ambient temperature. To do so, go to the parking function menu under direct operation and mark the auxiliary heating box.

NOTE: Initialization can only be carried out with the BMW diagnosis system.

Follow instructions and specifications in test module.

Service functions:

  • Complete vehicle
  • Body
  • Air conditioning function
  • Telestart transmitter
  • Initialization

OVERVIEW OF HEATER - A/C SYSTEM COMPONENTS

Auxil. Heater With Control Elements
Fig. 113: Identifying Heater And A/C System Components

  1. Condenser for air conditioner
  2. Drier insert for air conditioner
  3. Independent heater and attachment parts
  4. Water valve
  5. Heater - A/C system and attachment parts
  6. Fan and attachment parts
  7. Compressor

    READ NEXT:

     Removing And Installing Complete Independent Heater

    WARNING: Risk of scalding! Only perform the following repair work on an engine that has cooled down. Follow Notes for Repair Work on Cooling System. NOTE: Clamp off coolant hoses on independent heate

     Removing And Installing Or Replacing Fuel Pump

    Recycling Fuel escapes when fuel lines are detached. Have a suitable collecting vessel ready. Catch and dispose of escaping fuel. Observe country-specific waste disposal regulations. Undo screw (1

     Removing And Installing/Replacing Exhaust Pipe

    Necessary preliminary work Remove FRONT UNDERBODY PROTECTION NOTE: Graphic similar. Release screws (1). Remove lower left cover (2). Fig. 124: Identifying Lower Left Cover Screws Slacken nut (1).

    SEE MORE:

     Replacing Battery Positive Lead Between Starter, Alternator And Battery Positive Terminal (N63)

    Necessary preliminary tasks Read out fault memory of DME control unit Turn off ignition Disconnect BATTERY NEGATIVE LEAD Remove RIGHT INTERCOOLER Remove RIGHT INTAKE MANIFOLD Open cover. Release screw (1). Tightening torque 12 42 3AZ. Remove battery positive lead (2) from battery positive t

     Headlight Driver Module

    The headlight driver module controls and monitors the stepper motors for the adaptive headlights and the headlight beam throw adjustment system of the respective bi-xenon headlight. The integrated chassis management makes available the values for the dynamic headlight beam throw adjustment system

    © 2019-2025 Copyright www.bmw7g11.com