BMW 7 Series (F01/F02) 2008-2015 Service Manual / Electrical Drives
BMW 7 Series: Electrical Drives
- Electric Drives, Central Locking Unit/Unlocking Units
- Mirror Adjustment
- Servo/Positioning Drives
- Drive, Seat Adjustment
- Removing And Installing/Replacing Drive Unit For Backrest Angle Adjustment
- Removing And Installing/Replacing Drive For Backrest Tilt Adjustment (Comfort Seats In Rear Compartment)
- Removing And Installing/Replacing Drive Unit For Seat Height Adjustment
- Removing And Installing/Replacing Forward/Back Seat Adjustment Drive Unit
- Drive, Heating/Ventilation/Air Conditioning
- Drive, Slide/Tilt Sunroof/Convertible Top
- Drive, Power Window
- Drive, Roller Sun Blind/Sun Visor
- Drive, Seat Adjustment
READ NEXT:
Electric Drives
SAFETY INFORMATION FOR WORKING ON VEHICLES WITH AUTOMATIC ENGINE
START-STOP FUNCTION (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode),
the information "switch closed
Central Locking Unit/Unlocking Units
REMOVING AND INSTALLING OR REPLACING DRIVE UNIT FOR ROLLER SUN
BLIND
Necessary preliminary tasks
Remove REAR WINDOW ROLLER BLIND
Release screws (1).
Remove drive linkage (2).
Installation
Drive li
SEE MORE:
Electronic Ride-Height Control
Function of Air Springs
The various control modes on the F01/F02 are similar to those on other model
series such as the E70:
Fig. 131: EHC Control Mode Flowchart, F01/F02
Control Modes with Single-axle Air Suspension
Ongoing control operations are not affected by transitions from one mode to
anot
Removing And Installing/Renewing Heat Shield At Top (N63)
Necessary preliminary work
Remove both INTAKE FILTER HOUSINGS.
Remove both control sensors.
Release screws (1).
Lift out holder.
Fig. 468: Identifying Holder Screws
Release screw (2).
Tightening torque 11 65 3AZ.
Fig. 469: Identifying Screws And Heat Shield
Release screw (2).
Tightening to
© 2019-2026 Copyright www.bmw7g11.com
