BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine Electrical System / Electronic Switching Or Control Units / Coding Control Module (DME/DDE)
BMW 7 Series: Coding Control Module (DME/DDE)
Switch off ignition.
Connect MoDiC or DIS/GT1 Tester.
Switch on ignition.
Select "Coding" program.
For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.
Carry out adjustment of following control units:
- EWS (electronic immobilizer)
- DME (Digital Motor Electronics) or
- DDE (Digital Diesel Electronics)
Refer to "Diagnosis and Coding" service information bulletins on subject of coding.
PROGRAMMING CONTROL UNIT (DME/DDE)
Switch off ignition.
Connect MoDiC or DIS/GT1 Tester.
Switch on ignition.
Select "Programming".
For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.
Carry out adjustment of following control units:
- EWS (electronic immobilizer)
- DME (Digital Motor Electronics) or
- DDE (Digital Diesel Electronics)
Refer to "Diagnosis and Coding" service information bulletins on subject of programming.
READ NEXT:
Removing And Installing/Replacing Electronics Box
IMPORTANT: Read and comply with notes on protection against electrostatic
damage (ESD
protection).
NOTE: Follow instructions for removing and installing CONTROL UNITS !
Necessary preliminary work
R
Replacing Control Unit ((DME) (N63)
IMPORTANT: Read and comply with notes on protection against electrostatic
damage (ESD
protection)
Necessary preliminary work
Switch off ignition.
Disconnect BATTERY EARTH LEAD.
Drain coolant for
Replacing Crankshaft Pulse Generator (N63)
Necessary preliminary work
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove rear UNDERBODY PROTECTION.
Installation location
On transmission housing at bottom right.
SEE MORE:
Functions
Overview
When activated, the anti-theft system on the F01/F02 monitors the entire
vehicle. The doors and hood/trunk lid,
emergency current siren, the vehicle interior and the DWA bus in particular are
monitored. The anti-theft
system can be activated or deactivated at terminal 30. It is not possib
Removing Overrunning Equipment/Maintaining Or Replacing Guide
Bush/Installing Overrunning Equipment
After installing overrunning equipment, readjust brake system, refer to
ADJUSTING BRAKE SYSTEM
Check the guide bush while installed to ascertain whether it needs to be
replaced. Raise ball end area and
replace guide bush if play is detected in ball end area.
NOTE: After installing, readjust and ch
© 2019-2026 Copyright www.bmw7g11.com
