BMW 7 Series: Drive, Seat Adjustment
REMOVING AND INSTALLING/REPLACING LUMBAR SUPPORT DRIVE MECHANISM ON FRONT SEAT, LEFT OR RIGHT
Necessary preliminary tasks
- Remove rear panel on front seat backrest.
Unfasten plug connection (1) and disconnect.
Release clips (2).
Feed out drive unit for lumbar support in upward direction.
Installation: Replace faulty clips (2).
.png)
Fig. 68: Removing Lumbar Support Drive Unit In Upward Direction
Release cable tie (1) from jacket (2).
Feed out drive unit for lumbar support out of jacket (2).
Detach hose (3).
NOTE: Gently heat hose (3) if stuck.
Installation: Make sure hose (3) is laid without kinks.
.png)
Fig. 69: Identifying Lumbar Support Drive Unit Cable Tie, Jacket And Heat
Hoses
Electrical Drives - Tightening Torques
DRIVE, SEAT ADJUSTMENT
TIGHTENING TORQUE SPECIFICATION - DRIVE, SEAT ADJUSTMENT
.png)
MOTORS, POWER WINDOW REGULATOR
TIGHTENING TORQUE SPECIFICATION - MOTORS, POWER WINDOW REGULATOR
.png)
.png)
READ NEXT:
Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
Danger of poisoning!
Ingesting oil or absorbing through the skin may cause poisoning!
Possible symptoms are:
Headaches
Dizziness
Stomach aches
Vomiting
Diarrhoea
Cramps/fits
Unconsciousness
P
SEE MORE:
Replacing A Rear Pulse Sensor
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DAMAGE (ESD protection).
Necessary preliminary tasks
Remove rear WHEEL
Read and comply with GENERAL INFORMATION.
Open housing cover.
Disconnect plug connection (1).
Installation:
Ensure proper locking of plug connector a
Inline Connectors, 15-Pin, System D2.5
Notes
Carefully pull external connector (1) in area of retaining lugs (2) apart
slightly.
Fig. 65: Identifying External Connector And Retaining Lugs
Pull internal connector (3) until limit position in direction of arrow.
Fig. 66: Pulling Internal Connector In Direction Of Arrow
With special tool
