BMW 7 Series: Drive, Roller Sun Blind/Sun Visor
REMOVING AND INSTALLING OR REPLACING DRIVE UNIT FOR ROLLER SUN BLIND
Necessary preliminary tasks
- Remove REAR WINDOW ROLLER BLIND
Release screws (1).
Remove drive linkage (2).
Installation: Drive linkage (2) can only be installed in one position.
.png)
Fig. 63: Identifying Drive Linkage With Mounting Screws
Release screws (1).
Remove drive.
Installation: Ensure correct cable routing.
.png)
Fig. 64: Identifying Screws
REMOVING AND INSTALLING/REPLACING DRIVE FOR LEFT OR RIGHT ROLLER SUN BLIND
Necessary preliminary tasks
- Remove DOOR TRIM PANEL
Release screws (1).
Tightening torque 51 16 20AZ.
Release screw (2).
Tightening torque 51 16 19AZ.
.png)
Fig. 65: Identifying Door Trim Panel Mounting Screws
Unfasten plug connection (1) and disconnect.
Pull flex shaft out of drive.
Installation: Make sure flex shaft is correctly seated in drive.
.png)
Fig. 66: Identifying Roller Sun Blind Drive Plug Connection
Withdraw flex shaft (1) from gearing (2).
Installation: Make sure flex shaft (1) is correctly seated in gearing (2).
.png)
Fig. 67: Identifying Flex Shaft And Gearing
READ NEXT:
Drive, Seat Adjustment
REMOVING AND INSTALLING/REPLACING LUMBAR SUPPORT DRIVE MECHANISM
ON FRONT SEAT, LEFT OR RIGHT
Necessary preliminary tasks
Remove rear panel on front seat backrest.
Unfasten plug connection (1) and
SEE MORE:
Battery Replacement Information
A vehicle battery is constructed for the installation location and the
individual power requirements of the
particular vehicle. These individual power requirements depend on the
motorization and different types of
equipment. The individually assigned vehicle battery is the ideal compromise
betwee
Removing And Installing (Replacing) Control Unit For Automatic
Operation Of Tailgate System
IMPORTANT: Read and comply with notes on protection against electrostatic
damage (ESD
PROTECTION).
Necessary preliminary work:
DISCONNECT NEGATIVE BATTERY CABLE
Remove both battery earth leads at F03
Remove right LUGGAGE COMPARTMENT WHEEL ARCH PANEL.
NOTE: From 09/2010, the control unit is ins
