BMW 7 Series: Mirror Adjustment
REPLACING DRIVE UNIT FOR ELECTRICALLY OPERATED LEFT OR RIGHT
EXTERIOR MIRROR
Necessary preliminary work
- Remove MIRROR GLASS for inside mirror
NOTE: Picture for example purposes only!
Release screw (1).
Remove drive for electrically operated exterior mirror (2) in direction of arrow
from mirror housing (3).
.png)
Fig. 10: Removing Electrically Operated Exterior Mirror Drive
Installation note:
Make sure pin housing (2) is correctly seated in connector housing (3).
Fit drive for electrically operated exterior mirror (1) so that mountings (4)
slide in guides (5).
.png)
Fig. 11: Identifying Electrically Operated Door Mirror, Pin Housing, Plug
Housing And Locators
READ NEXT:
REMOVING AND INSTALLING/REPLACING LEFT HEADLIGHT VERTICAL AIM
ADJUSTER
WARNING: Version with xenon headlights: Danger to life due to high
voltage!
Therefore disconnect all components from voltage sup
DRIVE SEAT ADJUSTMENT REFERENCE CHART
Notes on initializing electric seat actuator drives
NOTE: Initialization is carried out at the adjusting switch of the
relevant seat.
In this process, the end
Necessary preliminary tasks:
Remove DRIVER'S or PASSENGER seat.
Remove REAR PANEL ON FRONT SEAT BACKREST
Remove COVERS ON FRONT SEAT
If necessary, disengage backrest cover (1) on left and right i
SEE MORE:
Concept
In the valet parking mode, the Control Display is
locked. The operation via iDrive is no longer possible.
E.g., this mode can be used when the vehicle is
handed over for valet parking.
General information
In the valet parking mode, it is not possible to
change vehicle settings via iDrive. P
REMOVING AND INSTALLING/REPLACING ANTI-ROLL BAR LINK (STABILIZER
LINK) FOR LEFT/RIGHT STABILIZER
IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Unscrew nuts (1).
Remove anti-roll bar link (2).
Installation note:
Replace self-locking nut.
Tightening torque 31 35 2AZ.
Fig. 79: Iden