BMW 7 Series: Wireless charging tray- Forgotten warning
General information
If the vehicle is equipped with the forgotten warning function, a warning can be output if a mobile phone with Qi capability was forgotten in the wireless charging tray when leaving the vehicle.
The forgotten warning is displayed in the instrument cluster
Activating
Via iDrive:
- "CAR"
- "Settings"
- "General settings"
- "Wireless charging tray"
- Activate reminder.
System limits
At high temperatures on the mobile phone or in the vehicle, the charging functions of the mobile phone may be limited and some functions may no longer work.
LTE-Compensator - Information and User Manual
Your car is equipped with a wireless charging tray (WCA) to charge your mobile phone and connect it to the mobile network. To ensure the best possible connection a signal booster (LTECompensator) is used in conjunction with the WCA. The following paragraphs refer to this booster: This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of Compensators. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. Warning E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please observe additionally the following information
- Sprint Nextel will allow consumers to register their signal boosters by calling their toll-free number.
Before use you must register your booster device with your wireless provider.
If you should be requested by the FCC to cease operating your booster you are not allowed to insert your mobile phone in the charging tray anymore unless the booster is permanently deactivated by your local BMW dealer.
You must not remove the booster from the car nor use it with any other than the preinstalled coupling device or antenna. Any modification of the existing antenna or coupling device as well as the use of other antennas or coupling devices will cause the cease of the booster´s operating license.
The booster device fulfills the network protection standards as required by the FCC, such as intermodulation limits, oscillation detection and gain limits.
Booster Manufacturer: Kathrein Automotive Model Number: LTECOMPB0 Part Number: 6803145-01 FCC-ID: 2ACC7LTECOMPB0
READ NEXT:
Folding table in the rear
General information
There is a folding table in the center armrest of
the rear console.
Safety information
Warning
A folded-out folding table protrudes into the
car's interior and, in case of accident
Storage compartments
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
SEE MORE:
Removing And Installing/Replacing Dynamic Drive Valve Block
Notes
WARNING: DANGER OF POISONING if oil is ingested/absorbed through the
skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic
system.
Do not draw off hydraulic fluid (risk of contamination).
Removing And Installing (Replacing) Smart Opener Bottom Sensor
Line (Non-Contact Rear Lid Opening)
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION).
Necessary preliminary work:
Remove COVER ON REAR BUMPER PANEL.
Release latch mechanisms (1) and remove control unit (2) in direction of
arrow.
Fig. 287: Identifying Control Unit And Latch Mecha
