BMW 7 Series: Storage compartments
Vehicle features and options
This chapter describes all standard, country-specific and optional features offered with the series.
It also describes features and functions that are not necessarily available in your vehicle, e.g., due to the selected options or country versions. This also applies to safety-related functions and systems.
When using these functions and systems, the applicable laws and regulations must be observed.
Storage compartments
General information
The vehicle interior contains multiple storage compartments for stowing objects.
Safety information
Warning
Loose objects or devices with a cable connection to the vehicle, for instance mobile phones, can be thrown about the car's interior while driving, for instance in the event of an accident, braking or evasive maneuver. There is a risk of injury. Secure loose objects or devices with a cable connection to the vehicle in the car's interior.
NOTICE
Anti-slip pads such as anti-slip mats can damage the dashboard. There is a risk of damage to property. Do not use anti-slip pads.
READ NEXT:
Front passenger side glove compartment
Safety information
Warning
Folded open, the glove compartment protrudes
in the car's interior. Objects in the glove compartment
can be thrown into the car's interior
while driving, for instance in the
Rear center armrest
General information
A storage compartment is located in the center
armrest between the seats.
Folding down
Reach into the recess and fold the center armrest
forward.
Opening
Depending on the equipme
Rear cup holder
Safety information
Warning
Unsuitable containers in the cup holders may
damage the cup holders or be thrown about
the car's interior in the event of an accident, an
evasive maneuver, or forceful
SEE MORE:
Removing And Installing/Replacing A Steering Stub/Wheel Carrier
Remove REAR WHEEL.
IMPORTANT: Expand anti-twist lock sufficiently to avoid damaging thread
when releasing
collar nut.
Release collar nut (1), activate parking brake for this purpose.
Installation note:
Replace collar nut, oil collar nut/wheel bearing contact surface only and
tighten down.
No oil
Removing And Installing/Replacing Right Intake Plenum (N63)
Necessary preliminary work
Remove right INJECTION PIPE.
Remove THROTTLE VALVE.
Release screws on intake plenum from above without fail before lowering
front axle.
Secure ENGINE in installation position.
Lower FRONT AXLE , releasing screws on engine mount first
Release A/C compressor and pla
