Reshaping or heating extruded sections and cast parts is not
permitted!
Failure to comply with this requirement would have the following
results:
In the case of reshaping, weld seams (E52) or glued connections (E60, E61,
E63, E64) tear in the
surrounding area.
In the case of reshaping, t
Notes
IMPORTANT:
1. Identify cause of damage (e.g. sharp-edged body parts, faulty
electrical
loads, jammed mechanisms, corrosion caused by ingress of water, etc.).
2. Read out fault memory.
3. Eliminate cause of damage.
4. Disconnect battery negative terminal.
5. Make sure that no safety-related