BMW 7 Owners & Service Manuals
BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Electrical System / Horn

BMW 7 Series: Horn

REMOVING AND INSTALLING/REPLACING LEFT FANFARE HORN

Necessary preliminary work

  • Remove FRONT LEFT WHEEL ARCH COVER
  • On vehicles with auxiliary heaters as equipment specification, remove BUMPER TRIM

Disconnect plug connection (1) and release nut (2).

Remove fanfare horn (3).

Horn
Fig. 276: Identifying Fanfare Horn With Plug Connection And Nut (61 33 050)

REMOVING AND INSTALLING/RENEWING RIGHT FANFARE HORN

Necessary preliminary work

  • Remove FRONT BUMPER TRIM

Disconnect plug connection (1) and release nut (2).

Remove fanfare horn (3).

Horn
Fig. 277: Identifying Fanfare Horn With Plug Connection And Nut (61 33 055)

REMOVING AND INSTALLING/REPLACING BOTH FANFARE HORNS

Necessary preliminary work

  • Remove FRONT BUMPER TRIM.

Unlock plug connections (1) and disconnect.

Release nut (2) and remove fanfare horns on right/left (3).

Horn
Fig. 278: Identifying Fanfare Horn With Plug Connection And Nut (61 33 060)

    READ NEXT:

     Insert Holder

    REMOVING AND INSTALLING/REPLACING 12V SOCKET IN CENTER ARMREST STORAGE COMPARTMENT Necessary preliminary tasks REMOVE CENTRE ARMREST STORAGE COMPARTMENT Remove 12V socket with special tool 61 0 250

     Control Units, Modules

     Initializing Rain/Light (Solar) Sensor

    NOTE: Initialization is necessary: after replacing windscreen after replacing rain/light (solar) sensor after replacing optics on rain/light (solar) sensor after installing a used rain/light (sol

    SEE MORE:

     Output Shafts

    PRESSING OUTPUT SHAFT OUT OF DRIVE FLANGE AND DRAWING IN Necessary preliminary work Remove REAR WHEEL. Remove REAR AXLE FINAL DRIVE. IMPORTANT: Always place a new circlip on the output shaft reinstalling! IMPORTANT: Expand anti-twist lock sufficiently to avoid damaging thread when releasing col

     Battery/Vapor Separator

    CARRYING OUT BATTERY "POWER RESET" IMPORTANT: Observe SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY. The following steps must be carried out for a "power reset" Switch off and disconnect battery charger Turn off ignition Vehicles with ID transmitter: Remove identification sensor from slot V

    © 2019-2026 Copyright www.bmw7g11.com