BMW 7 Series (F01/F02) 2008-2015 Service Manual / Slide/Tilt Roof
BMW 7 Series: Slide/Tilt Roof
- Sunroof
- Mechanical Sun Roof Components
- Adjusting Glass Slide/Tilt Sunroof Cover
- Removing And Installing Complete Glass Slide/Tilt Sunroof (Frame)
- Removing And Installing/Renewing Gasket For Water Gutter
- Removing And Installing/Renewing Rain Gutter For Glass Slide/Tilt Sunroof
- Replacing Carriage For Rain Channel On Left And Right
- Electrical Sun Roof Components
- Slide/Tilt Sunroof And Convertible Top
READ NEXT:
Sunroof
REPAIR INSTRUCTIONS FOR BONDED SEALS
1. General information on handling rubber seal profiles
If seals reveal partly detached protective film on delivery, they must
not be bonded.
Store seals at 5
Adjusting Glass Slide/Tilt Sunroof Cover
Ideal setting
Distance:
Distance (A) between lid and roof at front and rear must be the
same.
Insert special tool 00 9 341 between gasket and cover.
This check (sliding in and pulling ou
SEE MORE:
Instructions For Adapting Adjustment Unit For Reversing Camera
(CORGHI KDS Quick-Action Clamp)
The following operations should only be carried out when using the tool kit
for calibrating the reversing camera
for the first time.
NOTE: The operation is described for the left-hand side; proceed in the
same way for
the right-hand side.
Remove support plate (1) from spindle (2).
Replace spindle
Removing And Installing Vane Pump For Hydraulic Steering
NOTE: See procedure for POWER STEERING PUMP FOR POWER STEERING GEAR
WITH ACTIVE FRONT STEERING (N63) or POWER STEERING PUMP FOR
HYDRAULIC STEERING GEAR WITH DYNAMIC DRIVE (N63).
REMOVING AND INSTALLING/RENEWING DYNAMIC DRIVE EXPANSION HOSE
PART 2 (IN FRONT WHEEL ARCH)
Notes
WARNING: DANGER OF POISON
© 2019-2026 Copyright www.bmw7g11.com
