BMW 7 Owners & Service Manuals
BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Controls / General settings / Speed warning

BMW 7 Series: Speed warning

Concept

A speed limit can be set that when reached will cause a warning to be issued.

General information

The warning is repeated if the vehicle speed exceeds the set speed limit again, after it has dropped below it by 3 mph/5 km/h.

Adjusting

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4.  "Speed warning"
  5. "Warning at:"
  6.  Turn the Controller until the desired speed is displayed.
  7.  Press the Controller.

Activating/deactivating

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4.  "Speed warning"
  5. "Speed warning"

Setting your current speed as the speed warning

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Speed warning"
  5. "Select current speed"

Driver Attention Camera

Concept

A camera that monitors driver activity is located in the instrument cluster. The camera evaluates the head position and eye opening and uses the data to analyze the attention of the driver. This system supports various vehicle assistance systems, e.g.:

  • Fatigue alert.
  •  Steering and traffic jam assistant with Extended Traffic Jam Assistant.

    READ NEXT:

     Activating/deactivating

    Via iDrive: "CAR" "Settings" "General settings" "Driver Attention Camera"  Select the desired setting. System limits The Driver Attention Camera may not be fully functional in the followin

     Personal settings

     Data protection

    Vehicle features and options This chapter describes all standard, country-specific and optional features offered with the series. It also describes features and functions that are not necessarily ava

    SEE MORE:

     Rear head restraints

    Safety information Warning A missing protective effect due to removed or not correctly adjusted head restraints can cause injuries in the head and neck area. There is a risk of injury. Before driving, install the removed head restraints on the occupied seats. Adjust the head restraint so its ce

     Service Information

    Instrument Cluster Test Functions The test functions are shown in the TFT display of the instrument cluster. To Start Function Test Terminal R ON or terminal 15 ON. Press and hold the reset button in the instrument cluster for 10 seconds (set/reset). or by holding down the setting button in

    © 2019-2025 Copyright www.bmw7g11.com