BMW 7 Owners & Service Manuals

BMW 7 Series: Activating/deactivating

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Driver Attention Camera"
  5.  Select the desired setting.

System limits

The Driver Attention Camera may not be fully functional in the following situations:

  • When the Driver Attention Camera is covered by the steering wheel rim.
  • When the driver is wearing infrared impermeable sunglasses.

Activating/deactivating popup windows

For some functions, popup windows are displayed automatically on the Control Display.

Some of these popup windows can be activated or deactivated.

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Pop-ups"
  5. Select the desired setting.

The setting is stored for the driver profile currently used.

Control Display

Brightness

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "Displays"
  4. "Control display"
  5. "Brightness at night"
  6. Press the Controller.
  7. Turn the Controller until the desired brightness is set.
  8.  Press the Controller.

The setting is stored for the driver profile currently used.

Depending on the light conditions, the brightness settings may not be clearly visible.

Resetting the vehicle configuration

All individual settings can be reset to the factory settings when the drive-ready state is switched off.

Via iDrive:

  1. "CAR"
  2.  "Settings"
  3. "General settings"
  4.  "Reset vehicle data"
  5. "Reset vehicle data"

When the stored settings in a driver profile are synchronized with the ConnectedDrive account, these settings will remain in the ConnectedDrive account.

    READ NEXT:

     Personal settings

     Data protection

    Vehicle features and options This chapter describes all standard, country-specific and optional features offered with the series. It also describes features and functions that are not necessarily ava

     Driver profiles

    Concept Driver profiles can be created to store personal vehicle settings. If the vehicle is used by multiple drivers, each driver can create his personal driver profile. When a driver profile is sele

    SEE MORE:

     Head-Up Display

    ADJUSTING HEAD-UP DISPLAY NOTE: Vehicles with head-up displays are fitted with special windscreens. These windscreens are marked with the letters "HUD" on the outside at the bottom right below the seal (1). Prior to adjustment, fold seal (1) back and make sure that a correct windscreen is fitted.

     Removing And Installing Or Replacing Control Unit For Electric Fuel Pump

    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection). Necessary preliminary tasks Remove STORAGE COMPARTMENT in luggage compartment Disconnect plug connection (1). Unfasten screws (2). Remove control unit (3). Installation: Tightening torque 16 14 1A

    © 2019-2023 Copyright www.bmw7g11.com