BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Controls / Personal settings
BMW 7 Series: Personal settings
- Data protection
- Driver profiles
- Driver profiles- Guest profile
- Driver profiles- Setting up a PIN
- Driver profiles- Renaming a driver profile
READ NEXT:
Data protection
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
Driver profiles
Concept
Driver profiles can be created to store personal
vehicle settings. If the vehicle is used by multiple
drivers, each driver can create his personal driver
profile. When a driver profile is sele
Driver profiles- Guest profile
The guest profile can be activated by any driver.
Vehicle settings that are entered when the guest
profile is active will be stored in the guest profile.
In the following cases the guest profile is a
SEE MORE:
Replacing Shaft Seal For Drive Flange On Rear Differential
(Inserted Propeller Shaft)
Notes
IMPORTANT: Use only APPROVED OILS.
Failure to comply with this instruction will result in serious damage to the
rear
axle final drive!
Necessary preliminary tasks
Remove THREE-HOLE FLANGE
Remove retaining clip (1) and insert nut (2) with diaphragm seal.
Fig. 54: Identifying Retaining Cli
Oil Sump
REMOVING AND INSTALLING/REPLACING LOWER OIL SUMP SECTION (N63)
Necessary preliminary work
Remove underbody protection at front and rear.
Release oil drain plug and drain engine oil. See SERVICE - ENGINE OIL.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws (2) alon
© 2019-2025 Copyright www.bmw7g11.com
