BMW 7 Series: Slide/Tilt Sunroof And Convertible Top
FITTING AID
Fitting aid MW
SI number
01 13 10 (652)
.png)
Fig. 1: Identifying Fitting Aid (540250)
PIN
Pin MW
Note: (Centering pins) Contents 2 pieces. For installing (centering) glass slide/tilt sunroof.
Storage Location
C18
SI number
01 15 06 (281)
.png)
Fig. 2: Identifying Pin (541110)
TOOL
Tool MW
Note: (Tool set) For adjusting the slide/tilt sunroof
Consisting of:
1 = 0494795 Key
NOTE: Special Torx for tightening the slide/tilt sunroof screws
2 = 0494796 Template
.png)
Fig. 3: Identifying Tool (541240)
Slide/Tilt Roof and Convertible Top - Tightening Torques
ELECTRICAL SLIDE/TILT SUNROOF COMPONENTS
TIGHTENING TORQUE SPECIFICATION - ELECTRICAL SLIDE/TILT SUNROOF COMPONENTS
.png)
MECHANICAL COMPONENTS, SLIDE/TILT SUNROOF
TIGHTENING TORQUE SPECIFICATION - MECHANICAL COMPONENTS, SLIDE/TILT SUNROOF
.png)
.png)
READ NEXT:
Additional Work For Camber Correction
IMPORTANT: Changes in axle geometry caused by accidents must under no
circumstances
be rectified by camber adjustment!
NOTE: The upper control arm may only be replaced if the camber is outside
the
s
SEE MORE:
Removing And Installing/Replacing Exhaust Turbocharger, Right,
Cylinders 1-4 (N63)
Notes
IMPORTANT: Risk of fire if oil lines are leaking.
Risk of mixing up vacuum hoses.
Necessary preliminary work
Remove CATALYTIC CONVERTER , cylinders 1-4
Disconnect plug connection (1) on electric changeover valve (2).
Fig. 496: Identifying Plug Connection On Electric Changeover Valve
Relea
Steptronic transmission- Engaging selector lever positions
General information
To prevent the vehicle from creeping after you
select a drive mode, maintain pressure on the
brake pedal until you are ready to start.
Functional requirements
Only when the drive-ready state is switched on
and the brake pedal is depressed is it possible to
change from selector le
