BMW 7 Series: Removing And Installing/Replacing Complete Interior Roof Light (Rear)
Notes
Carefully lever out interior roof light (1) in direction of arrow with special tool 00 9 317.
.png)
Fig. 101: Removing Interior Roof Light Using Special Tool 00 9 317
Disconnect plug connection (1) and remove roof light (2).
.png)
Fig. 102: Identifying Plug Connection And Roof Light
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement:
- If necessary, remove bulbs
Note BULB TYPE
REMOVING AND INSTALLING/REPLACING FOOTWELL LIGHT (ON FLOOR TRIM PANEL, REAR)
Notes
Lever out footwell light (1) with special tool 64 1 020 in direction of arrow.
Disconnect plug connection behind and remove footwell light (1).
.png)
Fig. 103: Removing Footwell Light Using Special Tool 64 1 020
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement
If necessary, remove BULB.
REMOVING AND INSTALLING/REPLACING GLOVEBOX LIGHT
NOTE: Graphic is similar.
Lever out glove box light (1) in direction of arrow.
Disconnect plug connection and remove glove box light (1).
.png)
Fig. 104: Removing Glove Box Light
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement:
- If necessary, remove bulbs Note BULB TYPE.
REMOVING AND INSTALLING/REPLACING LUGGAGE COMPARTMENT LAMP (ON REAR LID)
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Lever out luggage compartment lamp (1) at openings (2) in direction of arrow.
Disconnect plug connection underneath and remove luggage compartment lamp (1).
.png)
Fig. 105: Removing Luggage Compartment Lamp
Replacement
- If necessary, remove bulbs
- Note BULB TYPE.
REMOVING AND INSTALLING/REPLACING MAKE-UP MIRROR LIGHT
Lever out mirror light (1) at rear in direction of arrow.
Disconnect plug connection underneath and remove mirror plate light (1).
.png)
Fig. 106: Removing Mirror Light
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement
- If necessary, remove bulb.
Note BULB TYPE.
READ NEXT:
Replacing Led For Front Door Trim Panel Light (Left Or Right)
Necessary preliminary tasks
Remove FRONT LEFT DOOR TRIM PANEL
Unlock LED for front door trim panel (1) from holder (2).
Detach LED for front door trim panel (1).
Installation
Make sure LED for fro
Follow Notes On Handling Led Lights (High-Performance Led)
WARNING: All LEDs with visible light have a certain secondary risk
potential due to
their dazzling effect:
If possible, do not look directly into the LED radiation without eye
protection - and above
SEE MORE:
System Components
Park Distance Control
The Park Distance Control of the F01/F02 is identifiable by the five
ultrasonic sensors on the front bumper. The
fifth sensor enables a high level of reliability in obstacle recognition to be
achieved despite the large front end
of the F01.
Fig. 136: F01/F02 Front Bumper Wit
Filling Bulkhead Cross-Member With Foam
For acoustic insulation reasons insulating foam is applied to the
finish-painted bodyshell in the bulkhead crossmember
area.
A 2-component PU cavity foam is used.
Sourcing reference for cavity foam, refer to BMW Parts Department.
Observe SAFETY AND APPLICATION INSTRUCTIONS.
Fig. 7: Identifying
