BMW 7 Series: Disc
SI number
01 22 06 (307)
.png)
Fig. 15: Identifying Disc (33 5 153)
SI number
01 22 06 (307)
.png)
Fig. 16: Identifying Disc (33 5 156)
SI number
01 22 06 (307)
.png)
Fig. 17: Identifying Disc (33 5 151)
SI number
01 22 06 (307)
.png)
Fig. 18: Identifying Disc (33 5 155)
READ NEXT:
Minimum set: Mechanical tools Extension MW
Note: (2 pieces) Pullout extension for 33 5 040, 33 5 050, 33 5 060.
Storage Location
A18
B18
SI number
01 21 06 (300)
Consisting of:
Fig. 19: Identifying E
Fixture MW
Note: For holding rear axle final drive during removal and installation.
SI number
01 01 07 (333)
Consisting of:
1 = 0496019 Joint
2 = 0496020 Frame
NOTE: (Main frame)
Fig. 21: Identifying
Minimum set: Mechanical tools Mandrel MW
Note: (drift) For driving radial shaft seal onto drive flange.
Storage Location
B26
SI number
01 09 09 (532)
Fig. 25: Identifying Mandrel (330150)
Mandrel MW
SEE MORE:
NOTE: Ride height adjustment must be carried out after the following work:
Removal/replacement of ride height sensor or its control rod (only
necessary for vehicles with air suspension or vehicles with VDC)
Replacement of wiring harness
Replacement of air supply system control unit (F01/F02/F04
Notes
Cylinders 1-4:
IMPORTANT: Risk of damage!
The exhaust camshaft must first be rotated in such a way that the camshaft is
free from tension when the bearing caps are released.
Necessary preliminary work
Remove right HIGH-PRESSURE PUMP
Remove right CYLINDER HEAD COVER
Remove right EXHAUST CAM