BMW 7 Series: Fixture
Fixture MW
Note: For holding rear axle final drive during removal and installation.
SI number
01 01 07 (333)
Consisting of:
1 = 0496019 Joint
2 = 0496020 Frame
NOTE: (Main frame)
.png)
Fig. 21: Identifying Fixture (335200)
3 = 0496077 Support
4 = 0496078 Fixture
NOTE: (Fixture for foam material insert)
5 = 0496079 Insert
NOTE: (insert) Foam material insert (1 set = 2 pieces)
5 = 0496080 Belt
NOTE: (Tensioning strap)
Holding sleeve
SI number
01 22 06 (307)
.png)
Fig. 22: Identifying Holding Sleeve (33 5 152)
Holding sleeve
SI number
01 22 06 (307)
.png)
Fig. 23: Identifying Holding Sleeve (33 5 154)
KEY
Key MW
Note: (Key) To counter-hold the drive flange - Replaced by universal key
MANDREL
Minimum set: Mechanical tools Mandrel MW
Note: (drift) For driving output shaft radial seal into rear axle final drive. Rear axle final drive: 215
Storage Location
B21
C21
SI number
01 01 07 (333)
.png)
Fig. 24: Identifying Mandrel (335140)
READ NEXT:
Mandrel
Minimum set: Mechanical tools Mandrel MW
Note: (drift) For driving radial shaft seal onto drive flange.
Storage Location
B26
SI number
01 09 09 (532)
Fig. 25: Identifying Mandrel (330150)
Mandrel MW
Open-End Wrench
Minimum set: Mechanical tools Open-end wrench MW
Note: Open-end spanner SW50 with retaining clip For releasing and tightening
down the insert nuts for the
screw connection of the propeller shaft on t
Spindle
Spindle MW
Note: (Spindle with nut) For device 33 0 000, for removing and installing
rubber mounts of rear axle support
mounting.
Storage Location
C25
B25
SI number
01 18 08 (482)
Consisting of:
Fig
SEE MORE:
Carrying Out Steering Angle Sensor Adjustment
IMPORTANT: In vehicles with active steering, steering angle sensor
adjustment is integrated
in the service function "INITIAL OPERATION/ADJUSTMENT FOR ACTIVE
STEERING " and must not be carried out separately!
NOTE: Steering angle sensor adjustment must be carried out:
after replacement of followin
BMW Drive Recorder
Concept
The system stores brief video recordings of the
surrounding area of the vehicle, e.g., to document
traffic events.
Additionally, the following parameters are stored
for the trip:
Date.
Time.
Vehicle speed.
GPS coordinates.
General information
There are various ways for storing video re
