BMW 7 Series: Extension
Minimum set: Mechanical tools Extension MW
Note: (2 pieces) Pullout extension for 33 5 040, 33 5 050, 33 5 060.
Storage Location
A18
B18
SI number
01 21 06 (300)
Consisting of:
.png)
Fig. 19: Identifying Extension (335070)
1 = 0495592 Extension
NOTE: (Extension (1 piece) )
Extractor MW
Note: (Rillex extractor) For bevel pinion and differential case (rear diff)/for installation of camshaft sprocket on crankshaft (M70)/for removing bearing inner race from drive flange (E36, E46)
Storage Location
B6
C6
.png)
Fig. 20: Identifying Extractor (331300)
Consisting of:
2 = 0492098 Washer
NOTE: (Disc) Replaced by 33 1 311.(0 492 107)
3 = 0492099 Washer
NOTE: (Disc) Replaced by 33 1 311.(0 492 107)
4 = 0492100 Washer
NOTE: (Disc) Replaced by 33 1 311.(0 492 107)
1 = 0492097 Connector
NOTE: (basic body) For transmission S5D 260Z, S5D 310Z and S5D 320Z;
5 = 0492101 Synchronizing key
NOTE: (Synchronizing key (old) )
6 = 0492102 Synchronizing key
= 0492103
7 = 0492103 Synchronizing key
8 = 0492104 Synchronizing key
9 = 0492105 Synchronizing key
NOTE: For rear axle final drive and for installation of the camshaft sprocket on the crankshaft (M70)
1 = 0492107 Washer
NOTE: (washer)
2 = 0492108 Synchronizing key
NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5
READ NEXT:
Fixture
Fixture MW
Note: For holding rear axle final drive during removal and installation.
SI number
01 01 07 (333)
Consisting of:
1 = 0496019 Joint
2 = 0496020 Frame
NOTE: (Main frame)
Fig. 21: Identifying
Mandrel
Minimum set: Mechanical tools Mandrel MW
Note: (drift) For driving radial shaft seal onto drive flange.
Storage Location
B26
SI number
01 09 09 (532)
Fig. 25: Identifying Mandrel (330150)
Mandrel MW
Open-End Wrench
Minimum set: Mechanical tools Open-end wrench MW
Note: Open-end spanner SW50 with retaining clip For releasing and tightening
down the insert nuts for the
screw connection of the propeller shaft on t
SEE MORE:
Chassis components
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily available in your vehicle, e.g., due
to the selected options or country versions. This
also applies to
Introduction
The F01/F02 with Slide/tilt Sunroof
The slide/tilt sunroof is an option on the F01/F02. Several control units are
involved in the operation of the
slide/tilt sunroof.
The roof control module controls and monitors the motors of the slide/tilt
sunroof.
The roof control module (FZD) is linked with
