BMW 7 Series: Box Wrench
Box Wrench MW
Note: For lock barrel screw connection (threaded ring) of tailgate E93 impact plate, tailgate
.png)
Fig. 2: Identifying Box Wrench (512040)
BRIDGE
Note: Gantry crane
SI number
6 04 03 (046)
DRIFT
Note: Replaces drift 51 2 194
FITTING AID
Minimum set: Mechanical tools Fitting aid MW
Note: For correct installation of upper rubber seal on windscreen.
Storage Location
A26
SI number
01 18 08 (482)
.png)
Fig. 3: Identifying Fitting Aid (513320)
GAUGE
Minimum set: Mechanical tools Gauge MW
Note: For measurement of retraction depth of window glass (replaces special tool 51 3 080 as of 10/2009).
SI number
01 22 09 (587)
.png)
Fig. 4: Identifying Gauge (510000)
GAUGE
Minimum set: Mechanical tools Gauge MW
Note: (test gauge for installing windscreen and rear window) (replaces special tool 51 3 210 from 06/2005)
Storage Location
B2
SI number
01 10 05 (189)
.png)
Fig. 5: Identifying Gauge (510010)
READ NEXT:
Handle
Handle MW
Note: (pull handles) Cutting wire pull handles fore removing rear,
quarterlight and side windows
SI number
01 13 03 (001)
Fig. 6: Identifying Handle (513270)
HOISTING WINCH
Note: for winds
Support
Minimum set: Mechanical tools Support MW
Note: (Bonnet support (2 x) ) For retaining engine compartment lid in working
position
Storage Location
B22
C22
SI number
01 22 06 (307)
Fig. 11: Identifying
Body - Operating Fluids
1.0 SEALING COMPOUNDS
Seam Sealer, Sikaflex 221 may be used to seal adjoining sheet metal parts
which create creaking noises due to
interactive contact. High-adhesion, polyurethane-based, black-color
SEE MORE:
Replacing Center Muffler (N63)
Notes
WARNING: Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Support center silencer with special tool 31 2 220 and a suitable universal
lifter.
Fig. 9: Identifying Centre Silencer With Special Tool 31 2 220
Release screws (1).
Tightening torque 18 20 6AZ.
Only
Removing Overrunning Equipment/Maintaining Or Replacing Guide
Bush/Installing Overrunning Equipment
After installing overrunning equipment, readjust brake system, refer to
ADJUSTING BRAKE SYSTEM
Check the guide bush while installed to ascertain whether it needs to be
replaced. Raise ball end area and
replace guide bush if play is detected in ball end area.
NOTE: After installing, readjust and ch
