BMW 7 Owners & Service Manuals
BMW 7 Series (F01/F02) 2008-2015 Service Manual / Body / Body Equipment - Special Tools

BMW 7 Series: Body Equipment - Special Tools

READ NEXT:

 Adjuster

Minimum set: Mechanical tools Adjuster MW Note: (Door lock tensioner) For pre-tensioning front and rear door locks when installing. Change to tool through use of noise-optimized locks from 02/2004. I

 Box Wrench

Box Wrench MW Note: For lock barrel screw connection (threaded ring) of tailgate E93 impact plate, tailgate Fig. 2: Identifying Box Wrench (512040) BRIDGE Note: Gantry crane SI number 6 04 03 (046)

 Handle

Handle MW Note: (pull handles) Cutting wire pull handles fore removing rear, quarterlight and side windows SI number 01 13 03 (001) Fig. 6: Identifying Handle (513270) HOISTING WINCH Note: for winds

SEE MORE:

 Introduction

History Voice-activated control was offered for the first time as an option for the E38. The system enabled the driver to operate the telephone and the navigation system without taking his or her eyes off the road and the traffic situation. As the voice recognition system evolved, the number of s

 Reinforcement Plate With Stud Bolt (Bonded)

In the case of a partial replacement piece, a body component is cut at a point described in the repair instructions. A reinforcement plate is bonded in to ensure sufficient strength. Reinforcement plates are available as new parts and must also be used. NOTE: The following graphics serve as genera

© 2019-2026 Copyright www.bmw7g11.com