BMW 7 Series (F01/F02) 2008-2015 Service Manual / Body / Side Panels
BMW 7 Series: Side Panels
- Cover For Side Member At Rear (Rear Side Panel Removed)
- Reinforcement Plate With Stud Bolt (Bonded)
- Replacing Left Rear Side Wall
- Replacing Outer Section Of Left Or Right Rear Wheel Housing (Side Panel Removed)
READ NEXT:
Cover For Side Member At Rear (Rear Side Panel Removed)
Read contents of BODY, GENERAL.
Use only approved SPOT-WELDING APPARATUS for repairs.
The following new bodywork parts are required:
Cover, side member, rear (component is included on new side pan
Reinforcement Plate With Stud Bolt (Bonded)
In the case of a partial replacement piece, a body component is cut at a
point described in the repair instructions.
A reinforcement plate is bonded in to ensure sufficient strength.
Reinforcement
Replacing Left Rear Side Wall
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following new body parts are required:
Side frame, rear
Reinforcement plate, C-
SEE MORE:
Sunroof
REPAIR INSTRUCTIONS FOR BONDED SEALS
1. General information on handling rubber seal profiles
If seals reveal partly detached protective film on delivery, they must
not be bonded.
Store seals at 5ºC to 40ºC.
If, during the handling, the protective film has come off before
bonding, it can st
Removing And Installing/Replacing A Steering Stub/Wheel Carrier
Remove REAR WHEEL.
IMPORTANT: Expand anti-twist lock sufficiently to avoid damaging thread
when releasing
collar nut.
Release collar nut (1), activate parking brake for this purpose.
Installation note:
Replace collar nut, oil collar nut/wheel bearing contact surface only and
tighten down.
No oil
© 2019-2026 Copyright www.bmw7g11.com
