The following instructions describe the permanent repair gluing of clips
which were originally secured with T-pins.
The repair gluing at the same time protects the area of the torn-off T-pin
perman
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
NOTE: Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following parts are required:
Roof outer skin
Additional required parts (no
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
NOTE: Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following parts are required:
Roof outer skin
Additional required parts (n
Notes
Manufactured by AMP: The following contact types without strand
sealing can be fitted in the connector
housings:
MQS (Micro Quadlock System)
MPQ, width 2.8 mm (Micro Power Quadlock)
MPQ, width 5.2 mm (Micro Power Quadlock)
Socket housing:
Press locks (1) on protective cap (2) upwards on
Necessary preliminary work
Remove left INJECTION PIPE.
Remove THROTTLE VALVE
Release screws on intake plenum from above without fail before lowering
front axle.
Secure ENGINE in installation position.
Lower front axle, releasing screws on engine mount first.
Release power steering pump, if