BMW 7 Series: Removing And Installing/Replacing Left Turn Indicator Insert
Necessary preliminary tasks
- Remove LEFT HEADLIGHT
Release screws (1) on headlight.
Tightening torque 63 12 6AZ.
Remove turn indicator insert (2) from headlight (3) towards top.
.png)
Fig. 72: Identifying Headlight Screws
Disconnect plug connection (1) on turn indicator insert (2).
.png)
Fig. 73: Identifying Plug Connection On Turn Indicator Insert
Replacement
Teach in turn indicator insert (2) via vehicle diagnosis.
- Service functions
- Body
- Lights
- Learning turn signal indicator
REMOVING AND INSTALLING/REPLACING LEFT TURN INDICATOR INSERT (LED HEADLIGHT)
Necessary preliminary tasks
- Remove HEADLIGHT
Release screws (1) on headlight.
Tightening torque 63 12 6AZ.
Pull turn indicator insert (2) out of headlight.
.png)
Fig. 74: Identifying Turn Indicator Insert And Screws
Disconnect plug connection (1) on turn indicator insert (2).
Installation note: Seal (3) and guides (4) on turn indicator insert (2) must not be damaged or missing.
.png)
Fig. 75: Identifying Turn Indicator Insert, Connector, Seal, And Guides
Replacement
Teach in turn indicator insert (2) via vehicle diagnosis.
- Service functions
- Body
- Lights
- Learning turn signal indicator
REMOVING AND INSTALLING/REPLACING RIGHT TURN INDICATOR INSERT
Operation is described in:
Removing and installing/replacing LEFT TURN INDICATOR INSERT
REMOVING AND INSTALLING/REPLACING RIGHT TURN INDICATOR INSERT (LED HEADLIGHT)
Operation is described in:
REMOVING AND INSTALLING/REPLACING LEFT TURN INDICATOR INSERT (LED HEADLIGHT)
READ NEXT:
Clearance And Side Marker Lamps
REMOVING AND INSTALLING/REPLACING REAR REFLECTOR (ON REAR BUMPER
TRIM)
Unclip reflector (1) from bumper trim (2) in area (3).
Pull reflector (1) out of guide and detach towards rear from bumper trim (
Fog Lights, Auxiliary Lights
REMOVING AND INSTALLING (REPLACING) LEFT HEADLIGHT FOR TARGET
ILLUMINATION
NOTE: The time value of this job item does not include adjustment of the
headlight for
target illumination!
ADJUSTMENT OF HE
SEE MORE:
Adjuster
Minimum set: Mechanical tools Adjuster MW
Note: (Door lock tensioner) For pre-tensioning front and rear door locks when
installing. Change to tool
through use of noise-optimized locks from 02/2004. Illustration items: 1 =
knurled nut 51 2 191 2 = support 51
2 192 3 = protection 51 2 196 4 = mandre
Replacing Actuator Drive For Right Footwell Flap
Necessary preliminary tasks
Remove INSTRUMENT PANEL TRIM
Position of actuator drive:
OVERVIEW OF ACTUATOR DRIVES ON HEATER/AIR CONDITIONER
Release screws (1).
Take off holder (2).
Fig. 73: Identifying Holder And Screws
Unclip connector piece (1) and slide downwards.
Latching of connector piece
