BMW 7 Owners & Service Manuals

BMW 7 Series: Comfort Access- Convenient closing

Safety information

Warning


With convenient closing, body parts can be jammed. There is a risk of injury. Make sure that the area of movement of the doors is clear during convenient closing.

Closing

Closing


Touch the grooved surface on the handle of a closed vehicle door with your finger and hold it there without grasping the door handle.

In addition to locking, the windows and glass sunroof with sun protection will be closed.

Opening the trunk lid

General information

If you open the trunk lid via Comfort Access, locked doors will not be unlocked.

To avoid locking the vehicle key in the vehicle, do not place the vehicle key in the cargo area.

Safety information

Warning


Body parts can be jammed when operating the trunk lid. There is a risk of injury. Make sure that the area of movement of the trunk lid is clear during opening and closing.

NOTICE


During opening, the trunk lid pivots back and up. There is a risk of damage to property. Make sure that the area of movement of the trunk lid is clear during opening and closing.

Opening

Opening


Press the button on the exterior of the trunk lid.

Opening and closing the trunk lid with no-touch activation

Concept

The trunk lid can be opened and closed with notouch activation using the vehicle key you are carrying. Two sensors detect a forward-directed foot motion in the central rear area and the trunk lid is opened or closed.

General information

To avoid locking the vehicle key in the vehicle, do not place the vehicle key in the cargo area.

If the vehicle key is in the sensor area, the trunk lid may open or close inadvertently if you unintentionally move your foot or if a foot movement is detected.

The sensor has an approximate range of 5 ft/1.50 m extending from the rear of the vehicle.

If you open the trunk lid with no-touch activation, locked doors will not be unlocked.

Safety information

Warning


During no-touch activation, vehicle parts may be touched, such as the hot exhaust gas system.

There is a risk of injury. When moving your foot, make sure you have a firm stance and do not touch the vehicle.

Warning


Body parts can be jammed when operating the trunk lid. There is a risk of injury. Make sure that the area of movement of the trunk lid is clear during opening and closing.

NOTICE


During opening, the trunk lid pivots back and up. There is a risk of damage to property. Make sure that the area of movement of the trunk lid is clear during opening and closing.

Performing the foot movement

  1. Stand in the middle behind the vehicle at approx.

    one arm's length away from the rear of the vehicle.

  2. Wave a foot under the vehicle in the direction of travel and immediately pull it back. With this movement, the leg must pass through the ranges of both sensors.

Performing the foot movement


Opening

Perform the foot movement described earlier.

Before the trunk lid opens, the hazard warning system flashes.

Closing

Perform the foot movement described earlier.

The hazard warning system flashes and an acoustic signal sounds.

Moving your foot again will stop the closing motion, and moving it one more time after that will re-open the trunk lid.

    READ NEXT:

     Comfort Access- Touchless unlocking and locking of the vehicle

    Concept The vehicle will be unlocked when the driver approaches the locked vehicle with the vehicle key. When the driver walks away from the unlocked vehicle with the vehicle key, the vehicle will be

     Trunk lid

    General information To avoid locking the vehicle key in the vehicle, do not place the vehicle key in the cargo area. It may not be possible to open the trunk lid when the vehicle is in valet parking m

     Valet parking mode

    Concept In the valet parking mode, the Control Display is locked. The operation via iDrive is no longer possible. E.g., this mode can be used when the vehicle is handed over for valet parking. Genera

    SEE MORE:

     More Functions

    Bi-xenon Headlights Bi-xenon headlights are installed as standard equipment and are located in the outer chamber of the headlights. In connection with the bi-xenon headlights, the shutter for the low beam light is activated by the "high beam ON" signal thus enabling the high beam light. High beam

     Replacing A Rear Pulse Sensor

    IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection). Necessary preliminary tasks Remove rear WHEEL Read and comply with GENERAL INFORMATION. Open housing cover. Disconnect plug connection (1). Installation: Ensure proper locking of plug connector a

    © 2019-2024 Copyright www.bmw7g11.com