BMW 7 Series: Fog Lights, Auxiliary Lights
REMOVING AND INSTALLING (REPLACING) LEFT HEADLIGHT FOR TARGET ILLUMINATION
NOTE: The time value of this job item does not include adjustment of the headlight for target illumination!
ADJUSTMENT OF HEADLIGHT FOR TARGET ILLUMINATION must be carried out after removal and installation!
IMPORTANT: Follow notes on HANDLING LED LIGHTS (HIGH-PERFORMANCE LED)
Necessary preliminary work:
- Remove ORNAMENTAL GRILLE IN BUMPER PANEL
Release screw (1).
Tightening torque 63 12 7AZ Remove headlight for target illumination (2) out of bumper panel in direction of arrow.
Unlock associated plug connection and disconnect.
.png)
Fig. 81: Removing Headlight For Target Illumination Out Of Bumper Panel
Replacement:
- Carry out VEHICLE PROGRAMMING/CODING
- ADJUST headlights for targeted illumination
REMOVING AND INSTALLING (REPLACING) RIGHT-HAND TARGETED ILLUMINATION HEADLIGHT
Operation is described in: REMOVING AND INSTALLING (REPLACING) LEFT HEADLIGHT FOR TARGET ILLUMINATION
REMOVING AND INSTALLING LEFT FRONT FOG LAMP
NOTE: The time value of this job does not include adjustment of the FOG LAMPS !
Necessary preliminary tasks
- REMOVE trim grille in bumper trim
Release screw (1).
Tightening torque 63 12 7AZ.
Remove fog lamp (2) in direction of arrow.
.png)
Fig. 82: Removing Fog Lamp
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS)
Disconnect plug connection (1) on fog lamp (2).
Remove fog lamp (2).
Replacement
- If necessary, turn bulb holder in direction of arrow and remove from fog
lamp (2).
Note BULB TYPE
.png)
Fig. 83: Turning Bulb Holder From Fog Lamp
REMOVING AND INSTALLING RIGHT FOG LAMP
Operation is described in: Removing and installing LEFT FOG LAMP.
REPLACING LEFT FOG LAMP
WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS).
Operation is described in: Removing and installing LEFT FOG LAMP.
Adjust FRONT FOG LAMPS.
REPLACING RIGHT FOG LAMP
WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS).
Operation is described in: Removing and installing LEFT FOG LAMP.
READ NEXT:
Overview Of Rear Lights
Fig. 84: Identifying Rear Light Cluster Components
Rear light, left (side panel)
Rear light, left (on tail panel)
Reflector, rear
Additional brake light
REMOVING AND INSTALLING/RENEWING CHROME
Replacing Rear Passenger Compartment A/C Control Panel Fan Motor
Necessary preliminary work
Remove REAR PASSENGER COMPARTMENT A/C CONTROL PANEL
Release screws (1).
Remove fan motor (3) from A/C control panel (2).
Installation note:
Make sure pins (4) are corre
SEE MORE:
Replacing Safety Battery Terminal (SBK)
CAUTION: Observe safety regulations.
Investigate cause of triggering of safety battery terminal.
To do so, read out fault memory of airbag control unit. Note fault
messages stored in memory. Rectify faults. Then clear fault memory.
Use of safety battery terminal:
From model year 1998 in Series E
Removing And Installing/Replacing Center Fresh Air Grille
Necessary preliminary work
F01, F02, F03, F12, F13:
Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE
F07, F10, F11, F18:
Remove decorative strip on dashboard on right
IMPORTANT: Proceed with care so as to avoid damaging the fresh air grille.
NOTE: Picture for example purposes only!
Replacement
R
