BMW 7 Series: Removing And Installing/Renewing Footwell Light
Lever footwell light (1) in direction of arrow out of panel for pedals (2).
Disconnect plug connection behind and remove footwell light (1).
.png)
Fig. 96: Removing Footwell Light
Lever footwell light (1) in direction of arrow out of door trim (2).
Disconnect plug connection behind and remove footwell light (1).
.png)
Fig. 97: Removing Footwell Light
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement: If necessary, remove bulb.
Note BULB TYPE.
REMOVING AND INSTALLING/RENEWING LUGGAGE COMPARTMENT LIGHT
NOTE: Open luggage compartment lid.
Lever out luggage compartment light (1) in direction of arrow.
Disconnect plug connection underneath and remove luggage compartment lamp (1).
.png)
Fig. 98: Removing Luggage Compartment Light
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (INTERIOR LIGHTS).
Replacement
- If necessary, remove bulb.
Note BULB TYPE.
REMOVING AND INSTALLING/REPLACING LED FOR CENTER ARMREST STORAGE COMPARTMENT
Necessary preliminary tasks
- Remove CENTER ARMREST STORAGE COMPARTMENT
Release cable tie (1).
Press LED (2) out of center armrest storage compartment (3).
.png)
Fig. 99: Identifying LED, Cable Tie And Center Armrest Storage Compartment
Detach trim (1) from LED (2).
Remove LED (2) from center armrest storage compartment (3).
Installation: Make sure trim (1) is correctly seated on LED for center armrest storage compartment (2).
Make sure electrical lead is correctly laid.
.png)
Fig. 100: Identifying LED And Center Armrest Storage Compartment
READ NEXT:
Removing And Installing/Replacing Complete Interior Roof Light
(Rear)
Notes
Carefully lever out interior roof light (1) in direction of arrow with
special tool 00 9 317.
Fig. 101: Removing Interior Roof Light Using Special Tool 00 9 317
Disconnect plug connection (1)
Replacing Led For Front Door Trim Panel Light (Left Or Right)
Necessary preliminary tasks
Remove FRONT LEFT DOOR TRIM PANEL
Unlock LED for front door trim panel (1) from holder (2).
Detach LED for front door trim panel (1).
Installation
Make sure LED for fro
SEE MORE:
Introduction
Refinements in Detail
The longitudinal dynamics systems described in this document comprise the
following:
Dynamic stability control (DSC) and
Electromechanical parking brake (EMF)
Both DSC and EMF are standard equipment on all F01/F02 models. Thus BMW has
consistently continued the
standards
Removing And Installing/replacing Left Or Right Tank Cover
Operations on right side analogous to left side shown. Use graphics in a
mirror-inverted way.
Release all screws (2).
Unscrew nut (3).
Feed out tank cover (1) towards rear above tension strut (4).
Fig. 97: Identifying Tank Cover, Screws And Nut
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT TO
