BMW 7 Series (F01/F02) 2008-2015 Service Manual / Body / Luggage Compartment Floor
BMW 7 Series: Luggage Compartment Floor
- Replace Luggage Compartment Floor And Both Side Members (Tail Panel Trim Removed)
- Replacing Luggage Compartment Floor, Left Section (Tail Panel Or Side Wall Removed)
- Replacing Rear Cross Member On Luggage Compartment Floor (Tail Panel Removed)
READ NEXT:
Replace Luggage Compartment Floor And Both Side Members (Tail
Panel Trim Removed)
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE.
Place vehicle on straightening bench.
These repair instructions comprise the procedures for REPAIR STAGE 3.
Following new body parts are require
Replacing Luggage Compartment Floor, Left Section (Tail Panel Or
Side Wall Removed)
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
NOTE: Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following new body parts are required:
Luggage compartment floor, left Follo
Replacing Rear Cross Member On Luggage Compartment Floor (Tail
Panel Removed)
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following new body parts are required:
End of luggage compartment floor Following
SEE MORE:
Adjusting Gear Lever (Parking Lock Emergency Release)
NOTE: Check cable for ease of movement.
Move gear selector switch to "P" position.
Control for emergency release must not be actuated.
Unfasten nut.
Disconnect cable (1).
Installation:
Release nut
Adjust cable by means of holder (2) until spacing A > or = 1 mm is
obtained.
Tighten down n
Integrated Universal Remote Control- Reprogramming individual
buttons
Switch on standby state.
Press and hold the interior mirror button to be
programmed.
As soon as the LED on the interior mirror
flashes orange after approx. 20 seconds, release
the button.
Hold the hand-held transmitter for the system
to be used approx. 1 to 12 in/2.5 to 30 cm
away fr
© 2019-2026 Copyright www.bmw7g11.com
