BMW 7 Series: Laser high beams
Concept
The range of the high beams is increased and ensures an even better illumination of the road.
General information
When the high beams are switched-on, starting with a speed of approx. 37 mph/60 km/h, the laser high beams in the headlight are automatically switched on in addition to the LED high beams.
Depending on the country variant, further information can be obtained from the laser label on the headlight.
Safety information
.gif)
The label is in the headlight and is visible from the outside.
Instrument lighting
Functional requirement
The parking lights or low beams must be switched on to adjust the brightness.
Adjusting
.gif)
Adjust the brightness with the
thumbwheel.
Interior lights
General information
Depending on the equipment version, interior lights, footwell lights, entry lights, ambient lighting, and speaker lighting are automatically controlled.
Overview
Buttons in the vehicle
.gif)
.gif)
Interior lights
.gif)
Reading lights
Switching the interior lights on/off
.gif)
Press the button.
To switch off permanently: press the button and hold for approx. 3 seconds.
The interior lights in the rear of the vehicle can be switched on and off independently. The button is located in the rear roofliner.
Switching the reading lights on/off
.gif)
Press the button.
Depending on the vehicle equipment, the reading lights are located next to the interior lights in the front and rear.
READ NEXT:
Ambient light
General information
Depending on the equipment version, lighting
can be adjusted for some lights in the car's interior.
Switching on/off
The ambient light is switched on when the vehicle
is unlocked,
Ambient highlight
General information
The ambient highlight illuminates the door pillars
in the rear.
When opening a rear door, the brightness of the
ambient highlight of the respective door pillar is
reduced. After t
SEE MORE:
Bonding On Painted Surfaces
IMPORTANT: Conform with safety regulations.
Overview of topics
Equipment
Expiry date of consumables
Preparation of surface
Bonding coat
Hardening times
Subsequent treatment
Disposing of adhesive
1.0 Equipment
CLEANER R1
Adhesive as specified in repair instructions
CARTRIDGE GUN
2.0 Exp
Notes Regarding The Fuel Pressure Test (Reference Pressure:
Surrounding Area)
The characteristic of this version with ambient pressure:
The connection for the vacuum hose of the fuel pressure regulator is located
between the throttle and the air
cleaner or on the air cleaner.
Test prerequisite:
The correct fuel pressure regulator is fitted.
Using the EPC, check whether the
