BMW 7 Series: Ambient highlight
General information
The ambient highlight illuminates the door pillars in the rear.
When opening a rear door, the brightness of the ambient highlight of the respective door pillar is reduced. After the rear door is closed, the ambient highlight is illuminated again in the previously adjusted brightness.
Switching on/off automatically
The ambient highlight is switched on when the vehicle is unlocked, and switched off when the vehicle is locked.
Via iDrive:
- "CAR"
- "Settings"
- "Interior lighting"
- "Ambient highlight"
The selected setting is stored for the driver profile currently used.
Switching on/off manually
The ambient highlight is fitted with a touch sensor.
The ambient highlight is switched on or off with a brief touch of the chrome bar.
Adjusting the brightness via iDrive
Via iDrive:
- "CAR"
- "Settings"
- "Interior lighting"
- "Ambient highlight"
- "Brightness" The last brightness set is displayed.
- Select the desired setting.
The selected setting is stored for the driver profile currently used.
Adjusting the brightness via touch sensor
The ambient highlight is fitted with a touch sensor.
The brightness is changed with a long touch of the chrome bar.
BMW Touch Command
The ambient highlight can also be operated using BMW Touch Command.
READ NEXT:
Airbags
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
Airbags- Protective effect
General information
Airbags are not triggered in every impact situation,
e.g., in less severe accidents.
Information on optimum effect of the
airbags
Warning
If the seat position is incorrect or the
SEE MORE:
Removing Hydraulic Chain Tensioner For Timing Chains On Right Side
(N63)
Notes
WARNING: Chain tensioner is pre-tensioned.
Release lock pin only in installed state.
Danger of injury!
IMPORTANT: Risk of damage!
The engine must not be cranked when the chain tensioner is removed.
The timing chain may jump.
Necessary preliminary work
Remove TIMING CASE COVER at top right
Fixture
Fixture MW
Note: For holding rear axle final drive during removal and installation.
SI number
01 01 07 (333)
Consisting of:
1 = 0496019 Joint
2 = 0496020 Frame
NOTE: (Main frame)
Fig. 21: Identifying Fixture (335200)
3 = 0496077 Support
4 = 0496078 Fixture
NOTE: (Fixture for foam material insert)
5
