BMW 7 Owners & Service Manuals
BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Controls / General settings / Language

BMW 7 Series: Language

Setting the language

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Language:"
  5. "System language"
  6. Select the desired setting.

The setting is stored for the driver profile currently used.

Setting the voice dialog

Set the voice dialog for the voice activation system.

Additional information: Setting the voice dialog

Setting the units of measurement

Depending on the country version, you can set the units of measurement for some values, for instance consumption, distances, and temperature.

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Units"
  5. Select the desired menu item.
  6. Select the desired setting.

The setting is stored for the driver profile currently used.

Trip data settings

Concept

The intervals in which the trip data will be reset can be configured.

Resetting trip data

Via iDrive:

  1. "CAR"
  2. "Settings"
  3. "General settings"
  4. "Reset trip data"
  5. Select the desired setting.

    READ NEXT:

     Speed warning

    Concept A speed limit can be set that when reached will cause a warning to be issued. General information The warning is repeated if the vehicle speed exceeds the set speed limit again, after it has d

     Activating/deactivating

    Via iDrive: "CAR" "Settings" "General settings" "Driver Attention Camera"  Select the desired setting. System limits The Driver Attention Camera may not be fully functional in the followin

     Personal settings

    SEE MORE:

     Memory function

    Concept The following settings can be stored and, if necessary, retrieved using the memory function: Seat position. Exterior mirror position. Steering wheel position. Height of the Head-up Display. General information Two memory locations with different settings can be set for each driver prof

     Open-End Wrench

    Minimum set: Mechanical tools Open-end wrench MW Note: Open-end spanner SW50 with retaining clip For releasing and tightening down the insert nuts for the screw connection of the propeller shaft on the rear axle final drive. Storage Location A18 SI number 01 21 06 (300) Fig. 32: Identifying Open-E

    © 2019-2026 Copyright www.bmw7g11.com