BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine / Crankshaft With Bearing
BMW 7 Series: Crankshaft With Bearing
READ NEXT:
Replacing All Crankshaft Main Bearing Shells (N63) Without Hybrid Drive
Notes
IMPORTANT: Risk of injury from sharp edge of housing.
IMPORTANT: If a crankcase or a crankshaft is replaced, old and new
identifications can be
used.
A mixed installation is permissible.
Exampl
Replacing Crankshaft (N63)
Notes
IMPORTANT: Weight of crankshaft is approx. 20 kg.
Risk of injury from sharp edge of housing.
Necessary preliminary work
Remove ENGINE
Mount engine on assembly stand
Remove cylinder head
Re
Flywheel
REMOVING AND INSTALLING/REPLACING FLYWHEEL (N63)
Necessary preliminary tasks
Remove AUTOMATIC TRANSMISSION
Remove manual transmission
Remove clutch
Secure flywheel (1) with special tool 11 9 260.
SEE MORE:
Notes On Handling Optical Fibres
IMPORTANT: To avoid damage when handling optical fibres, comply with the
following
points:
The minimum permitted bending radius is 25 mm
Do not subject optical fibres to compressive and tensile load
Protect optical fibres against the effects of heat > or =85 ºC (e.g.
during
welding work,
Replace Electrical Steering Box (EPS)
IMPORTANT: Steering box:
Check connection of steering box for corrosion, clean contacts if
necessary.
The steering box must be replaced if the corrosion is too far advanced.
Connecting line:
In the event of moisture/corrosion inside the two plug connections, check
the
insulation of the connecting
© 2019-2026 Copyright www.bmw7g11.com
