BMW 7 Owners & Service Manuals

BMW 7 Series: Climate control

Automatic climate control

Symbol/ Function

Temperature.


Air conditioning.


Maximum cooling.


AUTO program.


Recirculated-air mode.


Air flow, manual.


Air distribution, manual.


SYNC program.


Defrost and defog window.


Rear window defroster.


Active seat ventilation.


Seat heating.


Seat and armrest heating.


Ambient air package.


Refueling

Refueling

Fuel cap

  1. To open the fuel filler flap, press on the rear edge, arrow. The fuel filler flap opens.

Refueling


  1. Turn the fuel cap counterclockwise.
  2. Place the fuel cap in the bracket attached to the fuel filler flap.

Gasoline

For the best fuel efficiency, the gasoline should be sulfur-free or very low in sulfur content.

Fuels that are marked on the gas pump as containing metal must not be used.

Wheels and tires

Tire inflation pressure specifications

The tire inflation pressure specifications can be found in the tire inflation pressure table in the printed Owner's Manual.

After correcting the tire inflation pressure

With runflat tires: Reinitialize the Flat Tire Monitor.

With Tire Pressure Monitor: The corrected tire inflation pressures are applied automatically. Make sure that the correct tire settings have been made.

With tires that cannot be found in the tire pressure values on the Control Display, reset the Tire Pressure Monitor TPM.

Checking the tire inflation pressure

Regularly check the tire inflation pressure and correct it as needed:

  • At least twice a month.
  • Before embarking on an extended trip.

Cleaning the wheels

The friction during hard braking may produce brake dust and make the rims dirty. Brake dust can be removed by cleaning the rims. BMW recommends using vehicle care and cleaning products from BMW.

Electronic oil measurement

Functional requirements

A current measured value is available after approx.

30 minutes of normal driving with the combustion engine running.

Displaying the engine oil level

Via iDrive:

  1. "CAR"
  2.  "Vehicle status"
  3. "Engine oil level"

Different messages appear on the Control Display depending on the engine oil level. Pay attention to these messages.

Adding engine oil

General information

Safely park the vehicle and switch off drive-ready state before adding engine oil.

Adding engine oil

Adding engine oil


Only add engine oil when the message is displayed in the instrument cluster.

Observe the quantity to be added in the message.

Take care not to add too much engine oil.

Observe recommended engine oil types.

    READ NEXT:

     Providing assistance

    Hazard warning flashers The button is located in the center console. Breakdown assistance BMW Roadside Assistance Via iDrive: "APPS" "Installed apps" "BMW Assist" If necessary, "BMW Roadside A

     Controls

     Cockpit

    SEE MORE:

     Oscillating Motor

    Fig. 117: Identifying Oscillating Motor Housing And Oscillating Motor Shaft INDEX REFERENCE CHART Oscillating motor housing Oscillating motor shaft The hydraulic motor and the hydraulic motor body are each attached to one half of the anti-roll bar. The active anti-roll bar consists of the osci

     Removing And Installing Or Replacing Both Rear Brake Discs

    Necessary preliminary work Remove WHEELS. Remove and clean BRAKE PADS. After completing repair work: Adjust PARKING BRAKE (not F10F11F18F25) Read and comply with notes on BRAKING IN NEW BRAKE DISCS/BRAKE PADS. Check minimum brake disc thickness: Position special tool 34 1 280 at three meas

    © 2019-2022 Copyright www.bmw7g11.com