BMW 7 Series: Ambient air package- Inserting fragrance cartridges
The fragrance cartridges are located in the glove compartment.
- Open the glove compartment.
Front passenger side glove compartment
- Press on the bottom of the cartridge holder.
The cartridge holder slides down.
.gif)
- Remove the cover of the fragrance cartridge.
Hold the cover on the top to slide it from the fragrance cartridge.
.gif)
- Insert the removed cover on the back side of the fragrance cartridge.
.gif)
- Position fragrance cartridge such that the chip faces away from the cartridge holder.
.gif)
- Insert the fragrance cartridge without pressure into the cartridge holder. The cartridge snaps lightly into place.
.gif)
- Push the cartridge holder up, until it engages.
Make sure that no objects press against the cartridge holder from below, otherwise the function of the ambient air package could be impacted.
- Close the glove compartment.
Removing the fragrance cartridge
The fragrance cartridges are located in the glove compartment.
- Open the glove compartment.
Front passenger side glove compartment
- Press on the bottom of the cartridge holder.
The cartridge holder slides down.
.gif)
- Pull desired fragrance cartridge from the
holder.
Fragrance cartridge, arrow 1: first fragrance indicated on the Control Display.
Fragrance cartridge, arrow 2: second fragrance indicated on the Control Display.
.gif)
- Pull desired fragrance cartridge from the holder.
.gif)
Recycling
.gif)
Empty fragrance cartridges can
be taken
to a dealer's service center or another
qualified service center or repair shop for
recycling.
BMW Touch Command
The Ambient Air Package can also be operated using BMW Touch Command.
READ NEXT:
Integrated Universal Remote Control
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
Integrated Universal Remote Control- Reprogramming individual
buttons
Switch on standby state.
Press and hold the interior mirror button to be
programmed.
As soon as the LED on the interior mirror
flashes orange after approx. 20 seconds, release
the button.
SEE MORE:
Replacing Shaft Seal For Drive Flange On Rear Differential
(Inserted Propeller Shaft)
Notes
IMPORTANT: Use only APPROVED OILS.
Failure to comply with this instruction will result in serious damage to the
rear
axle final drive!
Necessary preliminary tasks
Remove THREE-HOLE FLANGE
Remove retaining clip (1) and insert nut (2) with diaphragm seal.
Fig. 54: Identifying Retaining Cli
Connection Diagram, Vacuum Activation (N63)
Fig. 462: Connection Diagram, Vacuum Activation (N63)
Connection (1) Black to exhaust flaps.
Distribute element (2), vacuum pump/vacuum reservoir (4).
Vacuum line (3) black to vacuum pump.
Vacuum reservoir (4) with three connections.
Connection, vacuum unit (wastegate), bank 2, cylinders 5 to
