BMW 7 Series: Removing And Installing Right Fog Lamp
Operation is described in: Removing and installing LEFT FOG LAMP.
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT AUXILIARY TURN INDICATOR
Notes
IMPORTANT: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS).
Slide front auxiliary turn indicator (1) with special tool 00 9 341 in upward direction and fold out in direction of arrow.
.png)
Fig. 66: Sliding Front Auxiliary Turn Indicator Using Special Tool
Disconnect plug connection (1). Remove front auxiliary turn indicator (2).
Installation: Make sure guides (3) and catch (4) are correctly installed.
.png)
Fig. 67: Identifying Front Auxiliary Turn Indicator And Plug Connection
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT AUXILIARY TURN INDICATOR TRIM
Notes
Slide front auxiliary turn indicator trim (1) with special tool 11 4 471 in upward direction and fold out in direction of arrow.
.png)
Fig. 68: Sliding Front Auxiliary Turn Indicator Trim Using Special Tool
Installation: Make sure guides (1) and catch (2) are correctly installed.
.png)
Fig. 69: Identifying Guides And Catch
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT SIDE REPEATER MIRROR (FROM 07/2012)
Necessary preliminary work:
- Remove EXTERIOR MIRROR ON FRONT DOOR
- Remove RETAINING RING ON EXTERIOR MIRROR
Release plug connection (1) on central connector (2) and disconnect.
.png)
Fig. 70: Identifying Plug Connection On Central Connector
Feed out cable (1).
Feed side repeater (3) in direction of arrow out of mirror housing (2).
.png)
Fig. 71: Identifying Side Repeater, Mirror Housing, And Cable
READ NEXT:
Removing And Installing/Replacing Left Turn Indicator Insert
Necessary preliminary tasks
Remove LEFT HEADLIGHT
Release screws (1) on headlight.
Tightening torque 63 12 6AZ.
Remove turn indicator insert (2) from headlight (3) towards top.
Fig. 72: Identify
Clearance And Side Marker Lamps
REMOVING AND INSTALLING/REPLACING REAR REFLECTOR (ON REAR BUMPER
TRIM)
Unclip reflector (1) from bumper trim (2) in area (3).
Pull reflector (1) out of guide and detach towards rear from bumper trim (
Fog Lights, Auxiliary Lights
REMOVING AND INSTALLING (REPLACING) LEFT HEADLIGHT FOR TARGET
ILLUMINATION
NOTE: The time value of this job item does not include adjustment of the
headlight for
target illumination!
ADJUSTMENT OF HE
SEE MORE:
Safety Information For Working On Vehicles With Automatic Engine
Start-Stop Function (MSA)
WARNING: If the engine hood/bonnet contact is pulled upwards (workshop
mode), the information "switch closed" is output. The automatic engine
start-stop function is active.
An automatic engine start is possible.
Observe safety precautions when working on MSA vehicles
Before carrying out practical
Transmission Suspension, Manual Transmission
REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING (N63)
Necessary preliminary work
Remove rear UNDERBODY PROTECTION.
Support transmission with lifter.
Release screws (1) and (2).
Remove transmission cross member.
Tightening torque 22 32 3/4AZ.
Fig. 9: Identifying Transmission Mounting Screws
R
