BMW 7 Series: Rear window roller sunblind
General information
The safety switch in the driver's door can be used to prevent children from operating the roller sunblind using the switches in the rear, for instance.
Additional information: Safety switch
Safety information
.gif)
NOTICE
When operating the roller sunblind, objects stored on the shelf may damage the roller sunblind.
There is a risk of damage to property.
Make sure that the area of movement of the roller sunblind is clear during the operation.
Overview driver's door
.gif)
.gif)
Button for the roller sunblind.
Overview of rear doors
.gif)
.gif)
Button for the roller sunblind.
Operation
.gif)
Press the button to open the
closed
roller sunblind or to close the open roller
sunblind.
If the button is pressed again during the movement, the roller sunblind is moved in the opposite direction.
Hold the button down to operate the roller sunblinds on the rear window and on the side windows at the same time.
BMW Touch Command
The roller sunblind can also be operated using BMW Touch Command.
System limits
If you are no longer able to move the roller sunblind after having activated it consecutively a number of times, the overheating protection mechanism is active. The system is blocked for a limited time to prevent overheating. Let the system cool.
The roller sunblind cannot be moved at low interior temperatures.
READ NEXT:
Roller sunblinds, rear side windows
General information
The safety switch in the driver's door can be
used to prevent children, for instance from operating
the roller sunblinds using the switches in
the rear.
Additional information:
Sa
Glass sunroof- Functional requirements
The glass sunroof and the sun protection can be
operated under the following conditions.
Standby state is switched on.
Drive-ready state is switched on.
The vehicle key must be in the car's interi
Glass sunroof- Jam protection system
Concept
The jam protection prevents objects or body
parts from becoming jammed between the roof
and glass sunroof while the glass sunroof is closing.
General information
If a resistance or blockage is
SEE MORE:
Active Rear Axle Kinematics
REMOVING AND INSTALLING/RENEWING INTEGRAL ACTIVE STEERING
Necessary preliminary tasks
LOWER REAR AXLE SUPPORT
Remove BOTH TOE ARMS
IMPORTANT: Screws (1) must not be released during removal!
Fig. 118: Identifying Screws
Unlock and disconnect plug connections (1) from steering.
Release screw (2)
Replacing Power Distribution Box (Luggage Compartment)
WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.
Necessary preliminary work
Clamp off BATTERY NEGATIVE LEAD
Disconnect both negative battery cables at F03
Remove FLAP IN LUGGAGE COMPARTMENT TRIM PANEL on right
If necessary, remove right WHEEL ARCH PANEL (at F01/F02/03)
Discon
