BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine / Oil Pump With Filter And Drive
BMW 7 Series: Oil Pump With Filter And Drive
- Removing And Installing/Replacing Oil Pump (N63)
- Removing And Installing/Replacing Roller Chain For Oil Pump Drive (N63)
READ NEXT:
Removing And Installing/Replacing Oil Pump (N63)
Notes
IMPORTANT: All adjusting procedures on the chain drive must be observed.
A timing chain which is tensioned too tautly can cause noises in the chain
drive.
A timing chain that is too slack can
Removing And Installing/Replacing Roller Chain For Oil Pump Drive
(N63)
Special tools required:
11 7 201
22 13 485
Necessary preliminary tasks:
Drain engine oil.
Remove flywheel.
Remove bottom of oil sump.
NOTE: Support bush (2) is included in delivery specificat
Oil Filter And Lines
OIL RETURN COVER
IMPORTANT: Risk of fire.
In the event of oil leakage in the Vee, the leakage oil may be ignited on hot
components.
Necessary preliminary work
Remove both exhaust turbochargers.
R
SEE MORE:
Voice activation system- Amazon Alexa Car Integration
Concept
Alexa is a digital voice-controlled assistant by
Amazon. With Amazon Alexa Car Integration,
Alexa can be used in the vehicle.
General information
Some of the Alexa functions are limited in the vehicle
to prevent any impairment of safety while
driving.
Functional requirements
Connected Voic
Replacing Crankshaft Pulse Generator (N63)
Necessary preliminary work
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove rear UNDERBODY PROTECTION.
Installation location
On transmission housing at bottom right.
Release connector (1) and remove.
Release screw (2).
Tightening torque 13 62 4AZ.
Withdraw puls
© 2019-2026 Copyright www.bmw7g11.com
