BMW 7 Series: Indicator/warning lights- Yellow lights
Steering and traffic jam assistant
The indicator light lights up
and an
acoustic signal may sound: a system interruption
is imminent.
The indicator warning light flashes: lane marking driven over.
Additional information: Steering and Lane Control Assistant
Antilock Braking System ABS
The Brake Assistant function may
not
activate. Avoid abrupt braking. Take the
longer braking distance into account.
Have the system immediately
checked
by a dealer's service center or another
qualified service center or repair shop.
DSC Dynamic Stability Control
.jpg)
The indicator light flashes: DSC
controls
the drive and braking forces. The vehicle
is stabilized. Reduce speed and modify
your driving style to the driving circumstances.
The indicator light lights up: DSC has malfunctioned.
Have the system immediately checked by a dealer's service center or another qualified service center or repair shop.
Additional information: DSC Dynamic Stability Control
DSC Dynamic Stability Control is deactivated or DTC Dynamic Traction Control is activated
.jpg)
DSC is deactivated or DTC is
activated.
Additional information:
- DSC Dynamic Stability Control
- DTC Dynamic Traction Control
Flat Tire Monitor FTM
The FTM signals a loss of tire
inflation
pressure in a tire.
Reduce your speed and stop cautiously.
Avoid sudden braking and steering maneuvers.
Additional information: Run-flat tires
Tire pressure monitor
The indicator light illuminates:
the Tire
Pressure Monitor reports a low tire inflation
pressure or a flat tire. Follow the information
in the Check Control message.
The indicator light flashes and is then illuminated continuously: flat tires or tire pressure losses cannot be detected.
- Interference caused by systems or devices with the same radio frequency: after leaving the area of the interference, the system automatically becomes active again.
- Tire pressure monitor was unable to complete the reset: reset the system again.
- A wheel without wheel electronics is mounted: have it checked by a dealer's service center or another qualified service center or repair shop as needed.
- Malfunction: have the system checked by a dealer's service center or another qualified service center or repair shop.
Additional information: Tire pressure monitor
Steering system
Steering system may not be
working.
Have the system checked by a dealer's service center or another qualified service center or repair shop.
Emissions
The warning light lights
up: Emissions are deteriorating. Have the vehicle checked as soon as possible.- The warning light flashes under certain circumstances:
This indicates that there is excessive misfiring
in the engine.
Reduce the vehicle speed and have the system checked immediately; otherwise, serious engine misfiring within a brief period can seriously damage emission control components, in particular the catalytic converter.
Additional information: Socket for Onboard Diagnosis
READ NEXT:
Indicator/warning lights- Green lights
Turn signal
Turn signal switched on.
Unusually rapid flashing of the indicator
light indicates that a turn signal bulb has
failed.
Additional information:
Turn signal
Parking lights
Parking lights a
Indicator/warning lights- Blue lights
High beams
High beams are switched on.
Additional information:
High beams
Gray lights
Active Cruise Control with Stop &
Go function
Indicator light is illuminated:
the system
is interrupted.
Ind
Fuel gauge
Concept
The current fill level of the fuel tank is displayed.
General information
Vehicle tilt position may cause the display to
vary.
Additional information:
Refueling
Display
An arrow beside the f
SEE MORE:
Replace Luggage Compartment Floor And Both Side Members (Tail
Panel Trim Removed)
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE.
Place vehicle on straightening bench.
These repair instructions comprise the procedures for REPAIR STAGE 3.
Following new body parts are required:
Luggage compartment floor, rear
Side member, left and right
Extension, side member, left and
Fixed Components
Some of the components that were modular in the Car Communication Computer
are now integrated into the
CIC as solid state components.
In the event of defects to some of the components, it may be necessary to
replace the entire head unit after
submitting a PuMA case.
Fig. 17: Bottom Open View Of
