BMW 7 Series: Indicator/warning lights- Green lights
Turn signal
.gif)
Turn signal switched on.
Unusually rapid flashing of the indicator light indicates that a turn signal bulb has failed.
Additional information: Turn signal
Parking lights
.gif)
Parking lights are switched on.
Additional information: Parking lights/low beams
Low beams
Low beams are switched on.
Additional information: Parking lights/low beams
Lane departure warning
The indicator light lights up:
the system
is activated. A lane marking was detected
on at least one side of the vehicle and
warnings can be issued.
Additional information: Lane departure warning
High-beam Assistant
High-beam Assistant is switched
on.
High beams are switched on and off automatically depending on the traffic situation.
Additional information: High-beam Assistant
Automatic Hold
.gif)
Automatic Hold is activated. The
vehicle
is automatically held in place when it is
stationary.
Additional information: Automatic Hold
Speed Limiter
.gif)
The indicator light lights up:
the system
is switched on.
The indicator light flashes: the set speed limit has been exceeded.
Additional information: Manual Speed Limiter
Cruise control
.gif)
Indicator light is illuminated:
the system
is active.
Additional information: Cruise control
Active Cruise Control with Stop & Go function
.jpg)
The indicator light lights up:
the system
is switched on.
Additional information: Active Cruise Control with Stop&Go function
Speed Limit Assist
.gif)
Indicator light illuminates
together with
the symbol for a cruise control system:
Speed Limit Assist is active and detected
speed limits can be applied manually for the displayed
system.
.gif)
Indicator light illuminates: the
detected
speed limit can be applied with the SET
button. As soon as the speed limit has
been applied, a green checkmark is displayed.
Additional information: Speed Limit Assist
Steering and traffic jam assistant
.jpg)
Indicator light lights up: the
system supports
the driver in keeping the vehicle
within the lane.
Additional information: Steering and Lane Control Assistant
Lane change assistant
Gray line for lane marking on the
appropriate
side: system detected a lane
change request. Lane change not currently
possible.
Arrow symbol for lane change
green: the
system carries out a lane change.
Arrow symbol for lane change
gray: lane
change not possible; functional requirements
not met.
Additional information: Steering and Lane Control Assistant
Extended Traffic Jam Assistant
.gif)
Indicator light is illuminated:
the system
is active.
Additional information: Steering and Lane Control Assistant
READ NEXT:
Indicator/warning lights- Blue lights
High beams
High beams are switched on.
Additional information:
High beams
Gray lights
Active Cruise Control with Stop &
Go function
Indicator light is illuminated:
the system
is interrupted.
Ind
Fuel gauge
Concept
The current fill level of the fuel tank is displayed.
General information
Vehicle tilt position may cause the display to
vary.
Additional information:
Refueling
Display
An arrow beside the f
Range
Concept
The range indicates the distance that can still be
covered with the current fuel level.
General information
The estimated range available with the remaining
fuel is permanently displayed in th
SEE MORE:
Replacing Complete Propeller Shaft Center Bearing
Necessary preliminary work
Remove PROPELLER SHAFT.
NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Installation note
Removing Camlock Retaining Cam On Loading Ramp
Drill out rivets (1).
Fig. 40: Identifying Loading Ramp Rivets
REMOVING CAMLOCK SCREW CAP
Bend back edges (1) of tab washer (2). Remove tab washer (2) over cross pin
(3) towards bottom.
Installation
Replace lockplate.
Fig. 41: Identifying Back Edges Of Tab Washer With Cross Pin
REMOVING AND INSTA
