BMW 7 Series: General Notes On Wheel And Tires (BMW Alpina B7)
NOTE:
- Pay attention to released wheel and tire combinations for BMW ALPINA.
- The valve for checking the tire inflation pressure is located under
the hub
cap.
Removing the hub cap
Press on emblem in area (1) and turn in direction of arrow.
.png)
Fig. 14: Turning Hub Cap By Pressing On Emblem
Open lock with key (1) and remove hub cap (2).
.png)
Fig. 15: Identifying Lock Key And Hub Cap
Installation note:
Make sure that there are 10 friction film pieces (see arrows) on the hub
cap.
When replacing the hub caps, the supplied friction film pieces must also be
attached.
.png)
Fig. 16: Locating Friction Film Faces On Hub Cap
Note on valve insert:
IMPORTANT: In the event of repair, only valve insert (1) may be replaced!
The screw valve (2) must not be removed from the wheel rim!
.png)
Fig. 17: Identifying Valve Insert And Screw Valve
READ NEXT:
Notes
IMPORTANT: Wheel was balanced electronically.
Observe safety instructions on raising the vehicle.
Follow instructions on initializing Run Flat Indicator (RPA).
When fitting all four wheels (e
Necessary preliminary work
Remove WHEEL
IMPORTANT: Use only BMW-approved balance weights.
Remove any fitted balancing weights, stones in tread pattern and larger
contaminants.
Check tire inflatio
SEE MORE:
WARNING:
Avoid contact with refrigerant and refrigerant fluid
Follow safety information for handling R134A refrigerant.
Follow safety information for HANDLING REFRIGERANT FLUID
IMPORTANT:
Always use new O-rings each time A/C connections are opened (refer to
Electronic Parts Catalogue)
They
Number of safety belts and
safety belt buckles
The vehicle is fitted with four or five safety belts
to ensure occupants' safety. However, they can
only offer protection when adjusted correctly.
The two outer safety belt buckles of the rear
seats are intended for the persons sitting on the
left and