BMW 7 Series: Wheels
- Checking Front And Rear Wheel For Lateral And Radial Runout
- Checking One Road Wheel On Balancing Machine For Lateral And Radial Runout (Wheel Removed)
- Checking Rim For Lateral And Radial Runout
- General Notes On Wheel And Tires (BMW Alpina B7)
- Remove Or Install Front Or Rear Wheel
- Stationary Wheel Balancing
READ NEXT:
Checking Front And Rear Wheel For Lateral And Radial Runout
Necessary preliminary tasks
Check wheel bearings
Lift vehicle.
Check wheel with special tool 36 1 030 (measuring fixture) for lateral runout.
Fig. 1: Checking Wheel Lateral Runout Using Special T
Checking One Road Wheel On Balancing Machine For Lateral And
Radial Runout (Wheel Removed)
Necessary preliminary work
Remove WHEEL
Mount wheel in balancing machine.
To avoid retooling errors, fit the wheel on the balancing machine in the same
way as it is also fitted on the car
(valve
Checking Rim For Lateral And Radial Runout
Necessary preliminary tasks
Remove WHEEL
Check WHEEL for lateral and radial runout
Remove TYRE from disc wheel
Remove dirt from rim well and rim flange
IMPORTANT: Disc wheels are not allowed to
SEE MORE:
Mandrel
Minimum set: Mechanical tools Mandrel MW
Note: (drift) For driving radial shaft seal onto drive flange.
Storage Location
B26
SI number
01 09 09 (532)
Fig. 25: Identifying Mandrel (330150)
Mandrel MW
Replaced by: 0491891
Note: (Drift) Replaced by 31 2 040.(0 491 891)
Mandrel MW
Replaced by: 0492338
Brake Testing And Bleeding
BLEEDING BRAKE SYSTEM WITH DSC
Necessary preliminary work
Remove left sensor opening
Read and comply with GENERAL INFORMATION.
IMPORTANT: When replacing or repairing, observe the filling and bleeding
instructions for
the following parts:
Tandem brake master cylinder
Hydraulic unit
Component
© 2019-2026 Copyright www.bmw7g11.com
