BMW 7 Owners & Service Manuals

BMW 7 Series: Front Camera

REMOVING AND INSTALLING/REPLACING CAMERA FOR LANE DEPARTURE WARNING

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION).

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Catches of two-part mirror base cover (1) must not be damaged.

Front Camera
Fig. 30: Expanding Two-Part Mirror Base Cover

Slide camera (1) in direction of arrow out of mounting.

Disconnect plug connection (2).

Installation:

Make sure camera (1) is firmly seated in mounting.

Replacement

Carry out calibration via BMW diagnosis system: Service functions:

  • Body
    • Lane departure warning
      • Calibrate camera

Front Camera
Fig. 31: Sliding Camera Out Of Mounting

    READ NEXT:

     Reversing Camera

     Calibrating Reversing Camera

    WARNING: Danger of injury! Laser beam at adjustment unit. Do not look into the beam! Laser class 2 As per EN 60825-1: 1994 P< or = 1 mW Lambda = 632.8 nm NOTE: Observe information on use of CORGHI

     Instructions For Adapting Adjustment Unit For Reversing Camera (CORGHI KDS Quick-Action Clamp)

    The following operations should only be carried out when using the tool kit for calibrating the reversing camera for the first time. NOTE: The operation is described for the left-hand side; proceed i

    SEE MORE:

     Fuel gauge

    Concept The current fill level of the fuel tank is displayed. General information Vehicle tilt position may cause the display to vary. Additional information: Refueling Display An arrow beside the fuel pump symbol shows which side of the vehicle the fuel filler flap is on. The current range is di

     Spindle

    Spindle MW Note: (Spindle with nut) For device 33 0 000, for removing and installing rubber mounts of rear axle support mounting. Storage Location C25 B25 SI number 01 18 08 (482) Consisting of: Fig. 37: Identifying Spindle (330050) 1 = 0496523 Spindle NOTE: (Spindle M18x1.5, length 365 mm) 2 = 04

    © 2019-2026 Copyright www.bmw7g11.com