BMW 7 Series: Automatic climate control- SYNC program
Concept
Depending on the equipment, the following settings of the driver's side can be transferred to the front-passenger side and the rear:
- Temperature.
- Air flow.
- Air distribution.
- AUTO program.
Switching on/off
.gif)
Press the button.
The LED is illuminated with the SYNC program switched on.
The program is switched off automatically if the settings on the front passenger side or in the rear are changed.
To defrost windows and remove condensation
Concept
Ice and condensation are quickly removed from the windshield and the front side windows.
Switching on/off
.gif)
Press the button.
The LED is illuminated with the system switched on.
The air flow can be adjusted manually with the system switched on.
.gif)
If there is window condensation,
press
the button on the driver's side or switch
on air conditioning to utilize the condensation
sensor. Make sure that air can flow to the windshield.
Rear window defroster
.gif)
Press the button. The LED lights
up.
The function is available with the engine running.
The rear window defroster switches off automatically after a certain period of time.
Microfilter/activated-charcoal filter
The microfilter removes dust and pollen from the incoming air.
The activated-charcoal filter also removes gaseous pollutants from the outside air that enters the vehicle.
Have this combined filter changed during vehicle maintenance.
READ NEXT:
Ventilation
Concept
The air flow directions can be individually adjusted.
CONTROLS Climate control
Adjusting the ventilation
General information
The air flow directions can be adjusted for direct
or indirect ven
Rear automatic climate
control
Overview
Buttons in the vehicle
Climate control functions
Button /Function
Temperature.
Maximum cooling.
AUTO program.
Air flow, manual.
Air distribution, manual
Active seat ventilation
Seat heating
Parked-car ventilation
Concept
The car's interior can be cooled or heated before
driving off with the parked-car ventilation. Depending
on set temperature and ambient temperature,
the car's interior is ventilated or possibl
SEE MORE:
Steering Arms, Tie Rods, Steer. Damper
INSTRUCTIONS FOR REMOVING AND INSTALLING EAR CLIPS
Notes
NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.
To remove an ear clip, place special tool 32 1 260 at right angles to ear and
cut ear open.
Fig. 75: Removing Ear Clip Using Special Tool (32 1 260)
The
Removing And Installing/Renewing Pressure Lines For Valve Block
(Short)
Notes
WARNING: DANGER OF POISONING if oil is ingested/absorbed through the
skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic
system.
Do not draw off hydraulic fluid (risk of contamination).
